Powerplus POW721 HOT GLUE GUN 78W EN - Manual (Page 2)

POW721 EN
Copyright © 2014 VARO P a g e | 2 www.varo.com
HOT GLUE GUN
POW721
1 APPLICATION
You can glue the following materials with the glue gun: wood, paper and cardboard as well as
some plastic materials.
WARNING! Read this manual and general safety instructions carefully
before using the appliance, for your own safety. Your power tool should
only be passed on together with these instructions.
2 PACKAGE CONTENT LIST
 Remove all packing materials
 Remove remaining packaging and transit supports (if existing)
 Check the completeness of the packing content
 Check the appliance, the power cord, the power plug and all accessories for transportation
damages.
 Keep the packaging materials as far as possible till the end of the warranty period.
Dispose it into your local waste disposal system afterwards.
WARNING Packing materials are no toys! Children must not play with
plastic bags! Danger of suffocation!
glue gun
2 pcs glue sticks
When parts are missing or damaged, please contact your dealer.
3 SPECIFIC SAFETY WARNINGS
 Be careful when you use the glue gun in spaces with inflammable material.
 Do not hold the glue gun over the same spot for a long time.
 Do not use the glue gun in explosive environments
 Keep in mind that the heat can conduct to inflammable material that is out of sight.
 Place the glue gun on the holder after use and let it cool off before storage.
 Do not leave the glue gun unattended when the cord is connected to the wall socket.
WARNING The glue gun is very hot during usage. It may cause burns on
the skin. Rinse immediately with cold water.!
4 OPERATION
 Connect the plug to the socket.
 The indicator lamp will shine when the glue gun is connected to the power gird.
 Place a glue stick in the opening on the back of the gun.
 Push in the glue stick as far as possible.
 Press the trigger several times to feed the glue stick forward.
 Press the trigger to feed glue forward when it has started to melt.
 Apply melted glue on the surfaces to be joined together, and then press the glued
surfaces together for 15 seconds.
 Unplug the plug after usage.