Powerplus POW67912 SUBMERSIBLE PUMP 400W SS EN - Manual (Page 7)

POW67900-02-04-06-12-15 EN
Copyright © 2013 VARO NV P a g e | 7 www.varo.com
10 SERVICE DEPARTMENT
 Damaged switches must be replaced by our after-sales service department.
 If the connecting cable (or mains plug) is damaged, it must be replaced by a particular
connecting cable which is available from our service department. Replacement of the
connecting cable must only be carried out by our service department (see last page) or by
a qualified person (qualified electrician).
11 TROUBLESHOOTING
Incidents Causes Remedies
Pump does not start - No mains supply
- Floater does not
switch
- Check mains supply
- Bring floater in a higher
position
No flow - Inlet sieve is clogged
- Pressure hose in
bent
- Clean inlet sieve water
jet
-
Reset hose
Pump does not switch off - Floater cannot sink down - Place pump properly on shaft
ground
Insufficient flow - Inlet sieve is clogged
- Reduced pumping
capacity by dirty and abrasive
water
- Clean inlet sieve
- Clean pump and replace
worn-out parts
Pump switches off after
short operating period - Thermal cutout stops
pumps due to dirty water
-
Water too hot.
Thermal-cutout stops pump
- Remove mains plug.
Clean pump and shaft
-
Make sure that a water
temperature of max. 35°C is not
exceed
12 STORAGE
 Thoroughly clean the whole machine and its accessories.
 Store it out of the reach of children, in a stable and secure position, in a cool and dry
place, avoid too high and too low temperatures.
 Protect it from exposure to direct sunlight. Keep it in the dark, if possible.

Don’t keep it in plastic bags to avoid humidity build-up.