Powerplus POW63755 LAWNMOWER139CC 457MM EN - Manual (Page 10)

POW63755
EN
Copyright © 2014 VARO P a g e | 10 www.varo.com
8.6 To stop engine
CAUTION: The blade continues to rotate for a few seconds after the engine
is shut off.
 Release the start/stop handle of the engine to stop engine and blade.
 Disconnect and ground the spark plug wire as instructed in the separate engine manual to
prevent accidental starting while equipment is unattended.
8.7 Auto move
Gently squeeze the bracket (2) of the self-traction. The lawn mower will then start its automatic
forward movement. Speed is approx. 0,9 m/s (3,1 km/h).
CAUTION: your mower is designed to cut normal residential grass of a
height no more than 250 mm. Do not attempt to mow through unusually tall
dry or wet grass (e.g, pasture) or piles of dry leaves. Debris may build up on
the mower deck or contact the engine exhaust presenting a potential fire
hazard.
8.8 Grass catcher bag (Fig. 9)
Empty and clean the bag, make sure it is clean and ensure its meshwork is ventilated.
8.9 Deck
The underside of the mower deck should be cleaned after each use to prevent a buildup of
grass clippings, leaves, dirt or other matter. If this debris is allowed to accumulate, it will invite
rust and corrosion, and may prevent proper mulching. The deck may be cleaned by tilting the
mower and scraping clean with a suitable tool (make certain the spark plug wire is
disconnected).
Do not tilt mower more then 30° towards the rear. If you want to tilt it more,
first drain fuel tank completely (see 9.3).
8.10 Height adjustment instructions
Caution: do not at any time make any adjustment to lawnmower without
first stopping the engine and disconnecting the spark plug wire.
Caution: before changing mowing height, stop mower and disconnect spark
plug cable.
Your mower is equipped with a central height adjustment lever offering 7 (20-28-36-46-56-66-
75 mm) height positions.
 Stop mower and disconnect spark plug cable before changing mower cutting height.
 The central height adjustment lever offers you 7 (20-27-35-45-55-65-75 mm) different
height positions. (6)
 To change the height of cut, squeeze adjuster lever toward the wheel, moving up or down
to selected height.
 All wheels will be in the same height of cut.