Extending the cords by hand, Changing the cord, Remove the cord spool (fig 3) – Powerplus POW6010P GRASS TRIMMER 250W 200MM EN User Manual
Page 8: Replace the cord in the cord spool, Insert the cord spool, Technical data, Noise

POW6010P
EN
Copyright © 2014 VARO
P a g e
| 8
www.varo.com
8.6
Extending the cords by hand
If the cords have already become too short they will not extend by tapping. You must pull them
out of the cord spool by hand.
Lay the product on the ground.
Press your hand on the bottom of the spool and pull the two cords out until they are
slightly longer than the edge of the protective shield.
The cords are cut to the right length by the cutting knife when used again.
8.7
Changing the cord
It is possible to replace the entire cord spool or just the cord.
8.8
Remove the cord spool (Fig 3)
Unscrew the lock
Remove the cord spool.
8.9
Replace the cord in the cord spool
Remove cord residues from the cord spool.
Roll up the cord in the cord groove.
8.10
Insert the cord spool
Insert the cord spool back into the cord spool housing and turn until the spool is firmly
seated.
Pull out both cords and thread into the cord guide.
Close the lid and screw the lock down tightly.
When used for the first time,the knife automatically cuts the cords to the right length.
9 TECHNICAL DATA
Rated voltage
230V
Rated frequency
50Hz
Rated Power
250W
No load speed
14000min
-1
Cutting width
200mm
Line size
Φ1.2mm
Cutting system
2 lines/tap & go
Weight
1,3kg
10 NOISE
Noise emission values measured according to relevant standard. (K=3)
Acoustic pressure level LpA
76 dB(A)
Acoustic power level LwA
96 dB(A)
ATTENTION! Wear hearing protection when sound pressure is over 85
dB(A).
aw (Vibration):
Max 8.0 m/s²
K = 1.5 m/s²