Powerplus POW30650 DRILL/SCREWDRIVER 14.4V EN - Manual (Page 8)

POW30650 EN
Copyright © 2013 VARO P a g e | 8 www.varo.com
9 CLEANING AND MAINTENANCE
9.1 Cleaning
§ Keep the ventilation slots of the machine clean to prevent overheating of the engine.
§ Regularly clean the machine housing with a soft cloth, preferably after each use.
§ Keep the ventilation slots free from dust and dirt.
§ If the dirt does not come off use a soft cloth moistened with soapy water.
Never use solvents such as petrol, alcohol, ammonia water, etc. These
solvents may damage the plastic parts.
10 TECHNICAL DATA
Voltage / frequency charging unit 230 V / 50 Hz
Rated Voltage 14.4 V
Rotation speed 1
st
gear 0-350 min
-1
Rotation speed 2
nd
gear 0-1250 min
-1
Torque positions 24
Max. drill capacity 10 mm
Charger time 3/5 hours
Battery capacity 1300 mAh
Battery type Ni-CD
Max. torque 15 Nm
Drill capacity concrete /
Drill capacity steel 10 mm
Drill capacity wood 20 mm
Chuck type Sanou keyless chuck
Number of speed settings 2
11 NOISE
Noise values measured according to relevant standard. (K = 3)
Acoustic pressure level LpA 74 dB(A)
Acoustic power level LwA 85 dB(A)
ATTENTION! The sound power level may exceed 85 dB(A), in this case
individual hearing protection shall be worn.
aw (Vibration) 6.5 m/s² K = 1.5 m/s²
12 SERVICE DEPARTMENT
§ Damaged switches must be replaced by our after-sales service department.
§ If the connecting cable (or mains plug) is damaged, it must be replaced by a particular
connecting cable which is available from our service department. Replacement of the
connecting cable must only be carried out by our service department (see last page) or by
a qualified person (qualified electrician).
13 STORAGE
§ Thoroughly clean the whole machine and its accessories.
§ Store it out of the reach of children, in a stable and secure position, in a cool and dry
place, avoid too high and too low temperatures.