Powerplus POW30070 IMPACT DRILL 600W EN - Manual (Page 5)

POW30070 EN
Copyright © 2014 VARO P a g e | 5 www.varo.com
8 OPERATION
8.1 Selecting the operation mode
Select the required operating mode before use (drilling or hammer drilling).
 For drilling in wood, metal, plastics and soft stone, push the switch (3) to the drill position.
 For drilling in concrete or hard stone, push the switch (3) to the hammer position.
8.2 Forward / reverse lever
 To select forward position (right rotation), push the forward / reverse lever to the right (R).
 To select the reverse position (left rotation), push the forward / reverse lever to the left (L).
8.3 Variable speed
This tool has a speed control dial (6) that delivers higher speed by turning to the “+” position
and delivers lower speed by turning to the “-“ position.
8.4 Switching ON and OFF
Connect the tool to the power supply.
To start the machine, you squeeze the ON / OFF switch (4).
To stop the machine, you release the ON / OFF switch.
8.5 Continuous mode
To switch the machine to continuous mode, keep the on/off switch pressed and at the same
time press the lock-on button (5). Subsequently release the on/off switch.
To switch off continuous mode, press the on/off switch again.
Never put down the machine when using the continuous mode!
9 CLEANING AND MAINTENANCE
Before performing any work on the equipment, pull the power plug.
9.1 Cleaning
 Keep the ventilation slots of the machine clean to prevent overheating of the engine.
 Regularly clean the machine housing with a soft cloth, preferably after each use.
 Keep the ventilation slots free from dust and dirt.
 If the dirt does not come off use a soft cloth moistened with soapy water.
 Never use solvents such as petrol, alcohol, ammonia water, etc. These solvents may
damage the plastic parts.
9.2 Maintenance
Our machines have been designed to operate over a long period of time with a minimum of
maintenance. Continuous satisfactory operation depends upon proper machine care and
regular cleaning.
10 TECHNICAL DATA
Voltage / Frequency 230V ~ 50Hz
Input power 600W
Chuck capacity Max.13 mm
No load speed 0 – 3000/min