Powerplus POW0350 VACUUM CLEANER WET/DRY 1000W 15L EN - Manual (Page 6)

POW0350 EN
Copyright © 201 VARO P a g e | 6 www.varo.com
7.3 Fitting and removing the motor housing
 The motor housing has been locked to the tub with clamps.
 To remove the motor housing (3). first remove the clamps (6) and then lift it from the tub
(7).
 To re-fit the motor housing, place it on the tub and tighten the damps.
7.4 Fitting the dust bag
A dust bag is suitable for collecting small waste material and dust.
 Remove the motor housing (3).
 Suspend the dust bag in the tub.
 Re-fit the motor housing.
7.5 Mounting the tube to the hose
 Slide the tube on the handgrip (11).
 Place the required nozzle on the tail end of the tube.
8 OPERATION
Make sure the power cord has been fully unwound before you switch on the machine. The air
leaving the grids must not be hindered.
When using the machine in combination with an electrical tool, switch on the machine first and
then the electrical tool.
8.1 Switching on and off
 To switch the machine on, set the on/off switch (1) to “I”.
 To switch the machine off, set the on/off switch (1) to "0".
8.2 Vacuuming up waste material
 Check whether the dust bag (14) has been fitted.
 Mount the tube (12) to the hose (10).
8.3 Vacuuming up dust released from an electrical tool
 Check whether the dust bag (14) has been fitted.
 Connect me hose (10) directly to the dust extraction outlet of the electrical tool.
8.4 Vacuuming up liquids
 Check whether the dust bag (14) has been removed.
 Make sure the inside of the tub (7) is clean and free from dust.
 Mount the tube (12) to the hose (10).
8.5 Emptying the tub
 Switch off and unplug the machine.
 Remove the motor housing (3).
 Empty the tub (7).