Powerplus POWAIR0802 PNEUMATIC DRILL/SCREWDRIVER EN - Manual (Page 6)

POWAIR0802 EN
Copyright © 2014 VARO P a g e | 6 www.varo.com
 If the drill bit does get caught while you are drilling, immediately release the trigger.

Flip the reverse knob to the “R” position as shown in Fig B. This will reverse the
rotation of the drill, allowing you to back out your drill bit.
 Lightly press the trigger until the drill bit spins free. Remove the air drill.
 Flip the reverse knob b
ack to the “F” position.
9 MAINTENANCE
WARNING: Disconnect wrench from air supply before changing
accessories, servicing or performing maintenance. Replace or repair
damaged parts. Use genuine parts only. Non-authorized parts may be
dangerous
1. Lubricate the air tool daily with a few drops of air tool oil dripped into the air inlet
2. DO NOT use worn, or damaged tool.
3. Loss of power or erratic action may be due to the following:
4. Excessive drain on the air line. Moisture or restriction in the air pipe. Incorrect size
or type of hose connectors. To remedy check the air supply.
5. Grit or gum deposits in the tool may also reduce performance. If your model has an
air strainer (located in the area of the air inlet), remove the strainer and clean it.
6. When not in use, disconnect from air supply, clean tool and store in a safe, dry,
childproof location.
10 TECHNICAL DATA
Model POWAIR0802
No load speed 1800 min-1
Operating pressure 6,2 bar
Diam. connection air inlet
¼”
Average air consumption 113 l/min
Chuck size 10mm
Chuck tyê Keyless
11 NOISE
Noise values measured according to relevant standard. (K=3)
Acoustic pressure level LpA
94 dB(A)
Acoustic power level LwA 105 dB(A)
ATTENTION! The sound power level may exceed 85 dB(A), in this case
individual hearing protection shall be worn.
aw (Vibration) 2.1m/s² K = 1,5 m/s²