Powerplus POW67920 SUBMERSIBLE PUMP 750W EN - Manual (Page 4)

POW67920 EN
Copyright © 2013 VARO NV P a g e | 4 www.varo.com
Mains supply
Your new submersible pump is equipped with a shock-proof plug according to regulations. The
pump is designed to be connected to a 230V - 50 Hz earthed socket. Make sure that the
socket is sufficiently secured (min. 6 Amp.) and is in excellent condition. Introduce the plug
into the socket and the pump is ready to go.
Important Note!
If the mains cable or plug suffers any damage from external action, repairs to the cable should
be serviced by a qualified specialist using only standard spare parts. This will ensure that it
meets the required safety standards.
7 SETTING TO WORK
After having read these instructions carefully, you can set your pump to work, reconsidering
the following:
 Check if the pump rests on the ground of the shaft.
 Check of pressure cord has been attached properly.
 Check if electrical connection is 230 V - 50 Hz.
 Check if socket is in good condition.
 Make sure that water and humidity can never come to the mains supply.
 Avoid pump running dry.
7.1 Venting the pump before use
 Always ensure that the pump is vented properly before commissioning the
pump. Possibly tilting back and forth several times until no more air bubbles
appear, wait at least 15 seconds before the pump to start.
This appliance cannot be used by children or people who are physically, mentally or
developmentally impaired, or people who lack experience or knowledge, except in case
these people receive instruction from a person responsible for their safety, a
supervisor, or by studying the preceding instructions concerning use of this appliance.