Electrolux Warm & Serve Drawer - Manual (Page 6)

6
Care & Cleaning
How to Clean
Use hot, soapy water and a cloth. Dry with a clean cloth.
To remove control knob, turn to the OFF position; grasp firmly and pull straight off the
shaft. Clean with a cloth soaked in soapy water.
Rinse with a clean water and a dishcloth.
Be sure to squeeze excess water from the cloth before wiping the panel; especially when
wiping around the controls. Excess water in or around the controls may cause damage
to the appliance. To replace knob after cleaning, line up the flat sides of both the knob
and the shaft; then push the knob into place.
Your appliance finish is made with Easy Care™ Stainless Steel (some models).
Clean the stainless with warm soapy water using a clean sponge or cloth. Rinse with
clean water and dry with a soft clean cloth. DO NOT use ANY store bought cleaners
like Stainless Steel cleaners or any other types of cleaners containing any abrasive,
chlorides, chlorines or ammonia. It is recommended to use mild dish soap and water
or a 50/50 solution of water and vinegar.
Gentle scouring with a soapy scouring pad will remove most spots. Rinse with a 1:1
solution of clear water and ammonia.
If necessary, cover difficult spots with an ammonia-
soaked paper towel for 30 to 40 minutes. Rinse with clean water and a damp cloth, and
then scrub with a soap-filled scouring pad. Rinse and wipe dry with a clean cloth. Remove
all cleaners or the porcelain may become damaged during future heating. DO NOT use
spray oven cleaners.
The rack may be removed for cleaning. Clean by using a mild, abrasive cleaner following
manufacturer's instructions. Rinse with clean water and dry.
Surfaces
Vinyl
Plastic
Control Knobs, Control Panel
Easy Care™ Stainless
Steel (some models)
Front Panel
Porcelain Enamel
Drawer Liner, Body Parts and
Drawer Cavity
Warmer Drawer Rack