Emerson Radio HD8100R - Manual (Page 7)

6
CONNECTING THE STEREO HEADPHONES AND REMOTE CONTROL
• Connect the plug of the supplied stereo headphones directly to the green-colored
PHONES jack on the left side of the cabinet.
• Or you may connect the headphones to the supplied Remote Control, then to
the PHONES jack.
Note: The control buttons PLAY/PAUSE, STOP, SKIP FWD and SKIP REV
function same as those on front panel.
NOTE: Make sure that the plugs are inserted into the jacks as far as they will
go. If the plugs are not fully inserted, you may only hear sound from one side
of the headphones.
IMPORTANT!
Always set the VOLUME control to a low level before you put the headphones on
and begin playing a CD. Then start playback and gradually increase the volume to
a comfortable listening level. Do not play the CD at loud volume levels that might
prevent you from hearing warning sounds such as car horns, etc.
U
L
T
I M
A T
E S K I P P R O T E C
T I O
N
PLAY/PAUSE
STOP
SKIP FWD.
SKIP REV.
HD8100R_031604.p65 16/3/2004, 14:17 6