beautypg.com

Trouble shooting specifications – EarthQuake Mega Bass Enhancer MB-1 User Manual

Page 6

background image

All specifications are subject to change without notice.

10

WWW.EARTHQUAKESOUND.COM

TROUBLE SHOOTING

No Power

If the LED on your dash remote is not on, check the POWER light on the chassis of MEGA BASS. If the POWER

light is on you will want to check to make sure that the cable connecting the remote to the chassis is not pinched or
disconnected. If th POWER light is off check to make sure that the power wire and remote turn on wires are connected or
a fuse has not blown.

No Restoration

When your system is playing and yet you don't hear any difference in the sound, try turning the knob clockwise. If

you still don't hear any affect, then you need to make sure that you have MEGA BASS in the right part of the signal chain.

Sound is Distorted

Should your system sound distorted or your speakers are moving way too much, you should decrease the amount

of bass restoration by turning the dash control knob counter-clockwise. You should also raise the DPF frequency or lower
the setting on you Bass Control.

Still No Good

Adjust the Bass controls by turning the sweep control clockwise to raise the center frequency. If you still have

distortion, you should power down MEGA BASS, and change the bass output settings inside the unit (See Page 7).

Trouble Shooting

Specifications

Maximum input level....................................................

Maximum output level..................................................

Frequency response....................................................

Total harmonic Distortion.............................................

Balanced input noise rejection.....................................

Input impedance..........................................................

Output impedance.......................................................

Power supply...............................................................

Power draw..................................................................

Recommended fuse rating..........................................

Dimensions..................................................................

Weight.........................................................................

MEGA BASS SPECIFICATIONS

15 Vrms

13.5 Vpeak

10Hz-80kHz; ±0.3dB

0.001%

> 60dB

10 Kohms

150 Ohms

High headroom PWM

160mA

1 Amp

H=1-1/8" W=8" D=5-1/2" + 1/4" For RCAs
1.70 Lbs

All specifications are measured at 14.4 VDC. As technology advances Earthquake reserves the right to continuously
change our specifications.

EARTHQUAKE SOUND • MEGA BASS DIGITAL SYNTHESIZER

9