Electrolux ZBQ 865 - Manual (Page 7)

7
Electronic programmer
1. Push button for selecting a function
2. Decreasing control button “ ”
3. Increasing control button “ ”
4. Display
5. “Cooking Duration” pilot lamp
6. “End of cooking” pilot lamp
7. “Minute minder” pilot lamp
8. “Time of day” pilot lamp
The oven will work only if the time of day has been set.
However, the oven can also be operated without any programme.
In the event of a power failure, all the settings (time of day, programme
setting or programme in operation) will be cancelled.
When the power is restored, the numbers in the display will flash,
and the clock/timer has to be reset.
Setting the time of day
When the power supply is switched on, or after a power failure, the “Time of
day” pilot lamp will flash on the display.
To set the correct time of day:
1.
Press button “ ” or “ ”.
2. After the setting is carried out, wait for 5 seconds: the “Time of day” pilot
lamp will go out and the display will show the set time. The appliance
is ready for use.
To reset the correct time of day:
1.
Press button repeatedly to select the “Time of day” function. The
relevant pilot lamp will start flashing. Then proceed as described above.
The time of day can only be reset if no automatic function (cook duration
or end of cooking ) has been set.
“Cooking Duration” function
This function allows the oven to automatically switch off at the end of a
programmed cooking duration time. Place food in the oven, select a cooking
function and adjust the cooking temperature. Press button
repeatedly to
select the “Cooking Duration” function. The relevant pilot lamp will start
flashing. Then, proceed as follows:
To set the duration time:
1.
Press button “ ” or “ ”.
2. After the setting is carried out, wait for 5 seconds: the "Cooking Duration"
pilot lamp
will come on and the display will revert to the time of day.
3. When cooking time is over, the oven will be switched off automatically
and an acoustic alarm will be heard, while the pilot lamp will start flashing.
Turn the oven function and the thermostat control knob to zero.
To switch off the acoustic alarm, press any button.
NOTE: turning the acoustic alarm off will reset the oven to manual, and
if the oven function and the thermostat knobs are not set to zero the
oven will start to heat again.
To cancel the duration time:
1.
Press button repeatedly to select the “Cooking Duration” function.
The relevant pilot lamp will flash and the display will show the remaining
cooking time.
2. Press button “ ” until the display shows “0:00”. After 5 seconds the
4
5
1 2 3
6
7
8