Electrolux LAVALOGIC 1620 - Manual (Page 41)

41
Electrical connection
Details about the voltage, type of supply and the fuses required are to
be found on the rating plate. The rating plate is next to the doorway.
Connecting to the water supply
Important!
• This appliance must not be connected to the hot water system.
• When connecting it, use only new hose kits.
• Only connect the appliance to the drinking water supply. Rain water
or water for industrial use may only be used if it fulfils the require-
ments of DIN1986 and DIN1988.
• Do not kink or crush the water inlet hose or drain hose.
Permitted water pressure
The water pressure must be at least 1bar (=10N/cm
2
=0.1MPa) and may
be a maximum of 10bar (=100N/cm
2
=1MPa).
– If more than 10bar: Connect a pressure reduction valve.
– If less than 1bar: Disconnect the appliance end of the inlet hose from
the solenoid inlet valve and remove the flow meter. (In addition re-
move the filter using pointed pliers and take out the rubber gasket
behind it.) Re-insert the filter.
Water inflow
A 1.50 m long pressure hose is supplied with the appliance.
If a longer water inlet hose is required, only original hoses are to be
used. The Customer Care Department stocks hose kits of different
lengths.
3
Sealing rings are either inserted in the nuts of the threaded hose fitting
or are included as spare parts . Do not use any other type of sealing
rings.
Important! All threaded hose fit-
tings must only be tightened by
hand.
1. Connect the hose with the right-an-
gle connector to the machine.