Epson D28114 - Manual (Page 16)

English
15
2. Place the wheel on the backing flange, centering the wheel on
the raised section (pilot).
3. Install the threaded clamp nut with the raised section (pilot)
facing away from the wheel.
4. Depress the spindle lock button and tighten clamp nut with
a wrench.
5. To remove the wheel, grasp and turn while depressing the
spindle lock button.
USING CUTTING WHEELS
WARNING: Do not use edge grinding/ cut-
ting wheels for surface grinding applications
because these wheels are not designed for side
pressures encountered with surface grinding.
Wheel breakage and injury may result.
1. Allow tool to reach full speed before
touching tool to work surface.
2. Apply minimum pressure to work surface,
allowing tool to operate at high speed.
Cutting rate is greatest when the tool
operates at high speed.
3. Once a cut is begun and a notch is established in the work-
piece, do not change the angle of the cut. Changing the angle
will cause the wheel to bend and may cause wheel breakage.
4. Remove the tool from work surface before turning tool off. Allow
the tool to stop rotating before setting it down.
MAINTENANCE
Cleaning
WARNING: Blowing dust and grit out of motor and switch actuator
using clean, dry compressed air is a necessary regular maintenance
procedure. Dust and grit containing metal particles often accumulate
on interior surfaces and could create an electrical shock or electro-
cution if not frequently cleaned out. It is recommended that a ground
fault circuit interrupter (GFCI) is utilized to further protect the user
from electric shock resulting from the accumulation of conductive
particles. If the tool is deactivated by the GFCI, unplug the tool and
check and clean the tool before resetting the GFCI. ALWAYS
WEAR SAFETY GLASSES when cleaning or using this tool.
CAUTION: Never use solvents or other harsh chemicals
for cleaning the non-metallic parts of the tool. Use a clean, dry
cloth only.
Lubrication
D E WALT tools are properly lubricated at the factory and are ready
for use.
Repairs
To assure product SAFETY and RELIABILITY, repairs, mainte-
nance and adjustments should be performed by a D
E WALT factory
service center, a D E WALT authorized service center or other quali-
fied service personnel. Always use identical replacement parts.
Accessories
Recommended accessories for use with your tool are available
at extra cost from your local dealer or authorized service center.
If you need assistance in locating any accessory, please contact
D
E WALT Industrial Tool Co., 701 East Joppa Road, Baltimore, MD
21286, call 1-800-4-D E WALT (1-800-433-9258) or visit our website
www.dewalt.com.
CAUTION: The use of any other accessory not recommended
for use with this tool could be hazardous.
Three Year Limited Warranty
D E WALT will repair, without charge, any defects due to faulty mate-
rials or workmanship for three years from the date of purchase.
This warranty does not cover part failure due to normal wear or
tool abuse. For further detail of warranty coverage and warranty
repair information, visit www.dewalt.com or call 1-800-4-D
E WALT