Electrolux EW502F - Manual (Page 14)

14
4. Unscrew and remove
the four feet. Fit the
grid on the bottom of
the machine and re-fit
the four feet. Tighten
up the lock nuts on all
feet.
5. Place the machine in
an upright position and
remove the three
plastic bolts.
6. Plug the 3 holes with
the plastic plugs which
you can find in the
envelope containing
the instruction booklet.
Installation
Transit security bars
Before starting the machine up, the transport
security bars must be removed as follows:
You are advised to keep all the transport security
bars in case the appliance has to be transported
again.
1. Unscrew and remove the
three rear screws by
means of a key.
2. Lean the appliance back
on the rear and fit one of
the polystyrene angles
between the appliance
and the floor.
Make sure the hoses
are not squashed.
3. Carefully remove the
plastic bags on the right
and the left, pulling them
to the centre of the
appliance
P0287
P0018
AL009
2
1
P0001
P0002