Euro-Pro EP133S - Manual (Page 6)

HOW TO OPERATE YOUR HAND VACUUM Changing and Cleaning the Post Motor Filter
1. Hold the hand vacuum firmly with your hand on the Handle (4).
2. Push the On/Off Power Switch (2) to “On” position.
3. Start vacuuming.
• Disconnect from electrical outlet before cleaning the filter.
• Filter should be cleaned at least twice a year or when it becomes visible solid.
• Always operate the cleaner with the filter installed.
• Do not use a washing machine to rinse the filter.
• Do not use a hair dryer to dry it.
CAUTION: The Hand Vacuum is a very powerful unit. Make sure
that you hold it firmly, otherwise it can slip out of your
hand and cause injury.
CHANGING & CLEANING THE DUST CUP FILTER
Warning: Always unplug from electrical outlet before opening the Dust Cup
(container) (10).
1. Push the Filter Cover Lock
(5) to open the filter cover (6).
2. Remove the filter from the
grill-filter.
3. Rinse filter in lukewarm
water and dry the
filter completely.
1. To open the Dust Cup (container) (10), push button (1) and pull out the Dust
Cup (container ) (10).
2. Pull out the Dust Cup Filter (13).
3. Empty the dust from the Dust Cup Container (10).
4. Rinse the Dust Cup Filter (13) in cold water, and then wait until it dries up
before replacing it into the Dust Cup (container) (10).
5. Place the Dust Cup Filter (13) carefully into the Dust Cup (container) (10).
6. Attach the Dust Cup (container) (10) to the Hand Vacuum.
4. Put the filter into the grill-filter.
5. A severely solid or clogged filter
should be thoroughly washed
with fresh tepid water. A mild
detergent can be used if
required.
CAUTION: The suction hole (3) must be open, free of any obstructions
at all times. Otherwise, the motor will overheat and could
get damaged.
4 5