Curtis SDVD9805 - Manual (Page 4)

Powering and installation
Plug one end of the AC/DC power adaptor into the DC IN 9-12V jack on the right of the
unit, then plug the other end into the AC power receptacle. Please refer to the following
illustration.
If using car cigarette lighter adaptor to connect to the power:
Plug one end of the cigarette lighter adaptor into the DC IN 9-12V jack on the unit, plug
the other end into the car cigarette lighter socket.See illustration below.
System Connection Main Unit Controls Overview of Unit A/B
Overview of Unit A
Overview of Unit B
Note
Car cigarette lighter adaptor is available to use only when the car cigarette lighter
with DC 12V negative grounding.
The mains plug is used as the disconnect device, the disconnect device should
remain readily operable.
1. Open knob
2. Power ON/OFF switch
3. SETUP button
4. MUTE button
5.
6. OK button
7. PLAY/PAUSE button
8. STOP button
1. Open knob
2. Power ON/OFF switch
3. SETUP button
4. MODE button
5.
6. OK button
7. PLAY/PAUSE button
8. STOP button
9. DC IN 9-12V
10. AV OUT
11. Earphone jack
12. Volume knob
13. Rating label position
14. Bracket
9. DC IN 9-12V
10. AV IN/OUT
11. Earphone jack
12. Volume knob
13. SD card slot
14. USB Port
15. Rating label position
16. Bracket
( )/
( )/
( )/
( )/
( )/
( )/
( )
( )
B UNIT
3 4 5 6 7 8
9
10
11
12
13
14
16
1 2
ON OFF
CLOSE
A V I N / O UT
15
SD
A UNIT
1 2
3 4 5 6 7 8
9
10
11
12
14 13
ON OFF
CLOSE
AV O U T
AV OUT
AV IN/OUT SD
AV OUT
AV IN/OUT SD
Car cigar ette lighter
Unit A
Unit A
Unit B
Unit B
4 5