Curtis SDVD1332 - Manual (Page 6)

MODE MODE
1
2
CR2025 CR2025
Please put the battery into the remote control as per below illustration
When using remote control, make sure the
infrared window is pointed to infrared receiving
window of the machine. The distance between
machine and remote control must be within 3
metres. Please refer to the following illustration.
Notice
1. To avoid falling off or place near damp environment.
2. To avoid infrared receiving window of the unit being under direct sunlight
3. Please use a new battery to replace old one if the remote control doesn't work.
The Use of Remote Control
Playing disc of DVD, SVCD, VCD, CD, MP3.
1. After connecting power to the unit, turn on the unit by sliding the ON/OFF switch to
ON, the source menu will be displayed on the screen:
Press to enter DVD mode or Media mode and press OK button to confirm.
When selecting "MODE", ensure to insert USB or SD/MMC card properly.
2. Open the disc door and insert a disc into the door with the label side facing up.
3. Close the disc door. The unit will load the disc and start playing.
4. Press once to stop playback; then press to resume playback from the point
where you stoped; press twice to stop playback completely.
5. During playback, press to pause; press it again to resume playback.
6. When the playing is finished, please turn off the power by sliding ON/OFF switch to OF F.
7. For some DVD disc with Title or Chapter menu, press “ MENU” button to enter menu
page, and use to select. Press ENTER to confirm.
Basic Operation
DVD SVCD VCD CD MP3
Note: Please do not disconnect USB devices or plug out SD/MMC cards while they are
working with the unit. Functional failure may occur in case of wrong operations.
Play/pause
Cursor button
ENTER
Title Menu
M ODE
9 8