Curtis SDVD1048 - Manual (Page 6)

8 9
Basic Operation
Playing disc of DVD, MPEG4, SVCD, VCD, CD, Mp3.
1.
2. Open the disc door and insert a disc into the door with the label side facing up.
3. Close the disc door.The unit will load the disc and start playing.
4. Press“ ”once to stop playback;then press“ ”to resume playback from the point
where you stoped;press“ ”twice to stop playback completely).
5. During playback,press“ ”to pause; press it again to resume playback.
6. When the playing is finished, please turn off the power by sliding ON/OFF switch to OFF.
7. For some DVD disc with Title or Chapter menu, press“MENU”button to enter menu
page, and use“ ”to select. Press ENTER to confirm.
DVD MPEG4 SVCD VCD CD MP3
Note:
Please do not disconnect USB devices or plug out SD/MMC cards while they are working
with the unit.Functional failure may occur in case of wrong operations.
In the Source Mode,you can press , ,to select and key to enter the
source you want.
“ ” “ ” “ENTER”
DVD SD USB
Play/pause
Cursor button
ENTER
Title Menu
1
2
CR2025 CR2025
Please put the battery into the remote control as per below illustration.
When using remote control,make sure the infrared window is pointed to infrared receiving
window of the machine.The distance between machine and remote control must be within
3 metres.Please refer to the following illustration.
The Use of Remote Control
0 30
0 30
Note:
1. To avoid falling off or place near damp environment.
2. To avoid infrared receiving window of the unit being under direct sunlight.
3. Please use a new battery to replace old one if the remote control doesn't work.
MODE