Curtis FR328D - Manual (Page 4)

3
the door. The ice will melt in a while. When it is over, pour down the water in the tray, wipe
the evaporator and the refrigerator can operate again.
NOTICE: Do not defrost the ice with sharp metal instrument in order to prevent the evaporator
from damaging.
ICE-MAKING
• Put water into the ice tray to the 3/4 heights and then place it to the bottom of evaporator.
Rotate the thermostat knob to the continue operation. As the ice-making finished, the
thermostat should be turn back in place to prevent storing food from freezing. Twist lightly the
ice tray, the cube ice can be taken out.
CAUTION
Before operating
• Check that if the voltage range of refrigerator includes your power voltage before connecting it
to the power. The voltage range is115V.
• The refrigerator must have a reliable grounding. If not, let the qualified personnel do it according
to the safety rules.
• Do not put the inflammable and explosive materials such as petrol, alcohol, adhesive, cigarette
lighter, gas cylinder into the refrigerator in case it explodes.
Caution during operation
• The refrigerator must not operate in the inflammable air. Do not use inflammable spray lacquer
near the refrigerator.
• To avoid injury, do not touch the inner wall of freezer compartment especially for the children.
• Do not spay the refrigerator with water in order not to damage the insulation of the parts and
speed up the corrosion.
FOOD STORAGE
• Hot food should not be stored until it has completely cooled. It is suitable for food to be frozen
after pre-cooling it in refrigerating compartment then freeze it.
• Do not freeze the glass-bottle liquid in case the bottle is broken for cold. Volatile liquids should
not be stored in the refrigerator.
• In order to allow air circulation, when placing foodstuffs, proper space should be kept between
food .To prevent from drying and mixing smells, food should be packed well.
CLEANING AND MAINTENANCE
• Pull down the plug first to cut off the electricity supplying for safety when clean the refrigerator.
• Take out the cabinet parts and clean and dry them.
• Clean the gaskets with a piece of soft cloth dampened in warm water or moderate detergent.
• Dust on compressor will influence heat diffusing. Please clean it periodically with soft brush or
dust cleaner.
• If the refrigerator will be out of use for a long time, disconnect the main power first, then remove
all the stored food and defrost and clean the cabinet. Leave the door open for one or two days
to dry the cabinet.