Curtis RLCVD3223A - Manual (Page 15)

WALL MOUNT INSTALLATION
INSTALLING REMOVING THE BASE STAND
WARNING
/
: The LCD Display is very fragile and must be protected at all times when removing the base
Stand
Be sure that no har d or sharp objector anything that could scratch or damage the LCD display comes into
contact with it Do NOT exert pressure on the front of the unit at any time because the screen could crack
1 Disconnect all cables or cor ds connected to the unit
2 Lay the unit down on a flat surface with the back side facing up Please make sure to place a soft
cushioned material such as a pillow or thick piece o f foam beneath the screen
3 To remove the base stand loosen screws off the holes then pull downwards to release
the base stand
4 To install the base stand put the stand into the hole at the bottom of the TV then insert screws to the
holes and tighten.
,
.
. .
. .
. .
. ,
.
. ,
MOUNTING ON THE W ALL
NOTE
Remove the b ase stand befor e mounting the unit on the wall.
This unit is VESA-compliant, and is designed t o be wall-mounted with a VESA-compliant 15.7” x 8”
(400mm x 200mm) mounting kit designed for flat- panel TVs (not supplied). Mount this unit according to
the instructions included in the mounting kit.
Length of screw should not exceed 12 mm.
15.7”
8”
M6
12