Electrolux EWX 14540 W - Manual (Page 41)

If you require any further advice please
contact your local water authority.
Electrical connection
Any electrical work required to install
this appliance should be carried out by
a qualified electrician or competent
person.
Important!
This appliance must be earthed.
The manufacturer declines any
liability should this safety measure
not be observed.
Before switching on, make sure the
electricity supply voltage is the same as
that indicated on the appliance’s rating
plate.
SHOWER
BATH
SINK TOILET
BIDET
WASHING
MACHINE DISHWASHER
RAINWATER
'RUN-OFF'
SURFACE WATER
DRAINS & SEWERS
UNTREATED
DISCHARGE
RIVER
FOUL DRAIN
FOUL SEWERS
SEWAGE
TREATMENT
WORKS
RIVER
P0987
TREATED
DISCHARGE
Important!
Information on the electrical
connection is given on the rating
plate on the inner edge of the
appliance door.
The appliance is supplied with a
13amp plug fitted. In the event of
having to change the fuse in the plug
supplied, a 13amp ASTA approved
(BS1363/A) fuse must be used.
Should the plug need to be replaced
for any reason, proceed as described
below.
The wires in the mains lead are
coloured in accordance with the
following code:
Green and Yellow......................- Earth
Blue ..........................................-
Neutral
Brown ......................................- Live
The wire coloured green and yellow
must be connected to the terminal
marked with the letter «E» or by the
earth symbol
or coloured green
and yellow.
GREEN & YELLOW
BROWN
CORD CLAMP
BLUE
13
A
P1041
E
N
L
installation electrolux 41
132972140 EN.qxd 26/10/2007 11.40 Pagina 41