Curtis RCD163A - Manual (Page 3)

English CONTROLS POWER SUPPLY
Top and front panels (See ) Power Supply
Whenever convenient, use the power supply if you
want to conserve battery life. Make sure you remove
the plug from the set and wall outlet before inserting
batteries.
Batteries (not included)
Open the battery compartment and insert eight
batteries, type R-14, UM-2 or C-cells, (preferably
Alkaline) with the correct polarity as indicated by the
"+" and "–" symbols inside the compartment.
Batteries contain chemical substances, so they
should be disposed of properly.
Incorrect use of batteries can cause electrolyte
leakage and will corrode the compartment or cause
the batteries to burst. Therefore:
• Do not mix battery types: e.g. alkaline with carbon
zinc. Only use batteries of the same type for the
set.
• When inserting new batteries, do not try to mix old
batteries with the new ones.
• Remove the batteries if the set is not to be used
for a long time.
Using AC Power
1 Check if the power voltage, as shown on the type
plate located on the bottom of the set, corresponds
to your local AC power supply. If it does not,
consult your dealer or service center.
2 Connect the power cord to the AC MAINS inlet and
the wall outlet. The power supply is now
connected and ready for use.
3 To switch off completely, unplug the power cord
from the wall outlet.
• Unplug the power cord from the wall outlet to
protect your set during heavy thunderstorms.
1
BATTERY DOOR
– to open battery compartment.
AC MAINS
– inlet for power cord.
Back Panel (See ) 1
VOLUME
- adjusts volume level.
FUNCTION SELECTOR
- selects source of sound CD, OFF or RADIO.
STEREO HEADPHONE JACK
- 3.5mm stereo headphone jack.
REPEAT
- repeats a track / CD / program.
PROGRAM
CD : - programs and reviews programmed
track numbers.
SEARCH ,
CD: - skips or searches a passage / track
backwards or forward.
STOP
- stops CD playback; erases a CD program.
PLAY/PAUSE
- starts or pauses CD play.
CD DOOR
- lift here to open / close the CD door.
TELESCOPIC ANTENNA
- pull out to improve to FM reception.
FM STEREO INDICATOR
- shows the FM stereo indication.
DIAL POINTER WINDOW
- shows the AM/FM dial frequency.
REPEAT INDICATOR
- shows the Repeat indication.
PROGRAM INDICATOR
- shows the Program indication.
DISPLAY
- shows the CD functions.
PLAY/PAUSE INDICATOR
- shows the Play/Pause indication.
TUNING CONTROL
- selects FM/AM stations.
BAND SELECTOR (FM ST.
- selects FM ST. / FM / AM waveband.
• FM • AM)
19
18
17
16
15
14
13
12
11
10
9
8
7
6
5
4
3
2
1
4 x 2 R14 • UM2 • C-CELLS
1
17 18 16 15 14 13
12 11 10
19
1 2 3 4 5 6 8 9 7
4 5
20
20