Curtis RCD157 - Manual (Page 3)

2
Whenever convenient, use the AC power supply if you want to conserve battery life.
Make sure you remove the AC cord from wall socket before inserting batteries.
PREPARATION FOR USE
1. AC mains operation
• Set the power selector to AC position.
• Take out the built-in AC power cord which is located inside the battery line cord compartment.
Connect the corresponding end to AC household mains outlet.
Make sure the voltage is compatible.
2. Battery operation
• Set power selector to DC position.
• Remove battery compartment cover.
• Put in 8 Batteries (UM-2 or equivalent ) in correct polarity as indicated. ( Heavy duty batteries are
recommend )
• Replace the cover properly.
NOTE : Check your batteries regularly. Old or discharged batteries should be replaced.
If the unit is not going to be used for some time or is being run exclusively on alternative
power. Take out the batteries to avoid leakage and damage.
E
LISTENING TO RADIO
Operation
1. Set the function selector to “ TUNER ” position.
2. Select the desired radio frequency with band selector.
3. Turn the Tuning control to set the Dial pointer against the station frequency as desired.
4. Adjust volume controls for the desired volume level.