Curtis DVD1046SUK User Manual

Page 6

CONNECTING DVD PLAYER - continued

CONFIGURE THE TV

The DVD player is set to UK PAL TV type as standard; if NTSC is required, see section 19 for set up.

7.1

Place the DVD player horizontal on a flat level surface.

7.2

Connect the DVD player to your TV and / or audio system (as shown in the previous diagrams), plug in
and switch on at the mains. The blue power light will illuminate.

7.3

Insert the batteries into the remote control.

7.4

Press the STANDBY button on the DVD player to turn on the player and turn on the TV and amplifier (if
connected).

7.5

Select the video mode (AV) for the TV. If there is more than one video channel (AV1, AV2, etc) select the
source that the DVD player is connected to. See the TV instruction manual for tuning instructions if the set
does not automatically tune.

CAUTION !

ALL EQUIPMENT MUST BE TURNED OFF AND DISCONNECTED FROM THE MAINS BEFORE

INSTALLATION

To HDMI
input

HDMI Cable
(not included)

To HDMI
output

Television

VIDEO

VIDEO OUT

AC 110-240V~
50/60Hz,10W

This manual is related to the following products:

DVD1053SUK