Curtis RT110 - Manual (Page 4)

P.12
OPERATION PROCEDURE / DVD PLAYER OPERATION
RADIO OPERATION
1. Slide the Power Sourcs Selector to
a correct position (ref. page 7-9)
2. Press the power button once.
3. Slide the TV-RADIO-OFF Switch to 'RADIO'
postion
4. For FM, slide the Band Selector to centre position.
For AM, slide the switch to the left. For Weather Band, switch
to right position.
5. Weather Band:
Select 162.400-162.475-162.550 Mhz to the best reception
depending on which states you are staying.
6. Tune the AM/FM radio to your desired station, The frequency
will show on the LCD Display.
7. For FM, fully extend the telescopic rod antenna for best
reception. For AM, the antenna is built into the unit. Reception
may be improved by changing the direction in which the unit
is facing.
8. Adjust the Volume control to desired sound level.
9. To turn the receiver off, press the power button.
10. Select Ant switch for best reception (See Page 7)
DVD OPERATION
1. Slide the Power Sourcs Selector to
a correct position (ref. page 7-9)
2. Press POWER to turn on the unit
3. Press OPEN
4. Insert a DVD disc
5. Press ' Close'
6. Use the cursor buttons on the unit or remote control to navigate the DVD
menu. Press ENTER to confirm selections.
During Play
Pausing and stopping playback :
- Press STOP once to hold place.
- Press PAUSE to pause the disc.
- Press PLAY to continue playback.
- Press " " to skip between scenes.
- Press << or >> on remote control to search the disc, rewind or forward.
- Press MENU on remote control to return to DVD menu.
- Press SLOW on remote control for slow motion.
- Press ANGLE on remote control for selecting movie angles.
- Press ZOOM on remote control for 1.5x, 2x, 4x and zoom off.
- Press SUBTITLE on remote control for subtitle options.
DVD Display
P.13
OPERATING PROCEDURES
TORCH LAMP OPERATION
1. Press the power button once.
2. Slide the 'OFF-Torch-Lantern' switch to the torch position.
3. Press 'Release' button and pull out the torch for independent
use, Make sure to put it back properly (Arrow to Arrow) to
prevent damage.
4. To turn the lamp off, press power switch to off position.
Note: The torch and radio can work at the same time.
Torch and TV can only work independently.
LANTERN OPERATION
1. Slide the 'Lantern' switch to 'ON' to light up the lantern.
2. To turn the Lantern off, slide switch to off position.
SIREN OPERATION
1. Press the power button once.
2. Press the 'Siren' button, siren sound will activate and all
other product functions will cease.
3. Turn siren off to resume other product functions in
operation.
HOW TO REPLACE THE LAMP TUBES
SPECIFICATION: Flourescent tube 4W/150mm
A. Release lamp cover screw
B. Lift up the lamp cover
C. Replace lamp tube and reassemble in
reverse procedures.
HOW TO REPLACE LIGHT BULB FOR TORCH
SPECIFICATION : Light bulb 3V/500mA
A. Turn counter-clockwise and lift up
the lamp cover.
B. Replace lamp tube and reassemble in reverse
procedures.
C. Be careful ! Don't drop any metal parts inside
when you lift up the lamp cover.
Chapter Mins Secs Hrs
Power Source Selector
EXT BATT CHARGE
Power
Power Source Selector
EXT BATT CHARGE
Power