First use – Parkside PSBSA 18-Li A1 User Manual

Page 46

PSBSA 18-Li A1

GB
MT

Changing tools

Your cordless combi drill has a fully automatic
spindle lock

When the motor is stopped, the power train is
locked so that the chuck can be opened by turn-
ing

. After you have attached the desired tool

and tightened it by turning the chuck

, you can

continue working. The spindle lock is automatically
released when the motor starts (ON/OFF switch
pressed ).

Selecting torque/operating mode

The torque selector allows adjustment of the torque
or selection between the drill setting and the
hammer drill setting .

♦

Select a low level for small screws or soft
materials.

♦

Select a high level for large screws, hard materials
or removing screws.

♦

Select the drill setting for drilling work by adjust-
ing the torque selection ring to the position .

♦

Select the hammer drill setting for hammer drilling
work by adjusting the torque selection ring to
the position .

2 speed gearbox

CAUTION!

►

Only operate the speed selection switch
when the appliance is at a standstill.
Otherwise the appliance can be damaged.

In ﬁ rst gear (speed selector switch in
position: 1)
you can reach a speed of approx. 440 rpm and
a high torque. This setting is suitable for all screw-
driving but also for the use of accessories.

In second gear (speed selector switch in
position: 2)
you can reach a speed of approx. 1650 rpm for
carrying out drilling work.

First use

Switching on and oﬀ

Switching on:

♦

To start the appliance, press and hold the ON/
OFF switch .
The LED work light illuminates when the
ON/OFF switch is depressed even lightly.

♦

This allows illumination of the work area in low
light conditions.

Switching oﬀ :

♦

Release the appliance’s ON/OFF switch to
switch oﬀ the appliance.

Setting the rotational speed

Pressing the ON/OFF switch lightly provides a
low rotational speed. Increasing pressure increases
the speed.

NOTE

►

The integrated motor brake ensures a quick
stop.

Changing the direction of rotation

♦

Change the direction of rotation by pressing the
rotational direction switch towards the left
or right.

Tips and tricks

Tip! This symbol indicates proper
behaviour!

♦

Before operation, check whether the screw or
drill bit is correctly positioned, i.e. centred in the
drill chuck.

♦

Screw bits are labelled according to their di-
mensions and their shape. If you are uncertain,
always check whether the bit ﬁ ts tightly in the
screw head without any free play.

Torque:

♦

Smaller screws/bits can be damaged if you set
the torque or rotational speed too high.

IB_102868_PSBSA18-LiA1_LB5.indb 43

09.10.14 12:02