Parkside PFBS 10.8 A1 - Manual (Page 55)

55 GB/MT
General safety advice for electrical power tools / Operation General safety advice for electrical power tools
RISK OF INJURY!
Switch the device off and allow it to come to a
standstill before you put it down.
Always keep the device
clean, dry and free of oil or grease.
Safety notices for chargers
This appliance can be used by children aged
from 8 years and above and persons with re-
duced physical, sensory or mental capabilities
or lack of experience and knowledge if they have
been given supervision or instruction concerning
use of the appliance in a safe way and under-
stand the hazards involved. Children shall not
play with the appliance. Cleaning and user
maintenance shall not be made by children
without supervision.
The charger is only suitable for
indoor use.
Q Operation
Never use the device for a purpose for which it was
not intended or with non-original parts / accessories.
The use of tools or accessories other than those rec-
ommended in the operating instructions could lead
to you suffering an injury.
Q
Charging the battery pack
NOTE! A battery pack that has been unused for a
while or never been charged must be charged before
reuse or first use. The battery pack requires about
3–5 cycles before it can reach its full charge. The
charging process takes about 180 minutes.
CAUTION! RISK OF INJURY! Always pull
out the mains plug (mains adapter
10 ) before
you insert the battery pack into or take it out of
the charger.
Insert the battery pack 4 into the charging
cradle 9 . This can only be inserted with the
correct polarity.
Connect the adapter 10 to a mains socket.
The red charge level indicator 11 will light up as
long as the battery pack is being charged. Once
charging is completed the red charge level in-
dicator
11 will extinguish and the green charge
level indicator 11 a will light up. The battery
pack 4 is ready for use.
CAUTION! Do not charge a battery pack for
a second time in close succession. There is a
danger of overcharging the battery pack.
Q Inserting / removing the
battery pack into / out of the
drill / grinder
Inserting the battery pack:
Set the ON / OFF switch 5 to position “0”.
Insert the battery pack 4 into the drill / grinder
until it engages.
Removing the battery pack:
Pressing the battery pack buttons 3 at the
sides at the same time allows you to remove
the battery pack
4 .
Q Reading off the battery status
The status or residual power is indicated as follows
in the battery-operated LED
2 whenever the appli-
ance is switched on:
RED / ORANGE / GREEN = maximum charge / power
RED / ORANGE = medium-level charge / power
RED = weak charge – recharge battery
Q
Inserting or replacing
a tool / collet
Press the spindle lock 8 and keep it pressed.
Rotate the clamping nut 6 until the lock
engages.
Loosen the clamping nut 6 with the combina-
tion key 23 .
If a tool is already inserted, remove it.
First insert the tool you wish to use through the
clamping nut
6 before you insert it into the
collet 18 suitable for the tool shaft.