Parkside PMFW 310 A1 - Manual (Page 39)

39 GB/MT
General power tool safety warnings General power tool safety warnings / Assembly
you are using the device. Pull the plug
out of the mains socket immediately and have
the device repaired by a suitably qualified per-
son or at your service centre. Damaged mains
leads increase the risk of electric shock.
Wear protective gloves when replacing
a tool in the device. Tools heat up with
prolonged use.
Use the electrical power tool only for
dry abrading / sawing / cutting.
Do not operate the device if it is damp
and do not use it in a damp environ­
ment. Water entering an electrical device in-
creases the risk of electric shock.
Keep your hands away from the area
of the saw blade. Do not grip the underside
of the workpiece. Contact with the saw blade
may result in injury.
Use a suitable detector to locate con­
cealed services supply cables / pipes
or approach your local public utilities
services providers. Contact with electricity
cables can lead to fire or electric shock.
Damaging a gas pipe can lead to an explo-
sion. Penetration of a water pipe can lead to
property damage or to electric shock.
If you use the device outdoors, always
connect it through a residual current
device (RCD) with a maximum trip cur­
rent of 30 mA. If using an extension lead, al-
ways use one that is approved for outdoor use.
Any harmful / noxious dusts
generated from sanding represent a risk to the
health of the person operating the device and
to anyone near the work area.
Wear safety glasses and a dust pro­
tection mask!
Ensure that there is adequate ventila­
tion when working on plastic, paint,
varnish etc.
Do not soak the materials or the sur­
face you are about to work on with
liquids containing solvents.
Q Advice on use
Principle of operation:
The oscillating drive causes the attached tool to vi-
brate backwards and forwards up to 21000 times
per minute. This means the tool can produce precise
work in the tightest of spaces.
Sawing / cutting:
Use only undamaged, defect-free saw blades.
Distorted, blunt or otherwise damaged saw
blades could break.
When sawing lightweight building materials,
observe the statutory requirements and the
manufacturer’s recommendations.
Use the device in plunge sawing mode on soft
materials such as wood, gypsum plaster board
etc. only!
Sanding:
Ensure that you use even contact pressure. This
will increase sanding sheet life.
Q Assembly
Q Vacuum extraction of
dust / debris
Do not use the tool on materials containing asbestos.
Asbestos is a known carcinogen.
DANGER OF FIRE! There is
the danger of fire when working with electrical
devices that have a dust box or can be connected
to a vacuum cleaner. Under certain conditions the
wood dust in the dust extraction bag (or in the vac-
uum‘s dust bag) may ignite, e.g. as a result of flying
sparks generated when abrading metals or metal
objects left in wood. This can happen particularly if
the wood dust is mixed with paint residue or other
chemicals and the abraded particles are hot from
prolonged abrasion. Therefore you must empty the
device’s dust collection box and the vacuum clean-
er’s dust bag before taking a break or stopping
work and always avoid overheating of the abrad-
ed particles and the device.