Parkside PMFW 310 A1 - Manual (Page 26)

26 GB
Introduction / General power tool safety warnings Introduction
Multi-Purpose Tool PMFW 310 A1
Q Introduction
We congratulate you on the purchase of your new
device. You have chosen a high quality product. The
instructions for use are part of the product. They
contain important information concerning safety,
use and disposal. Before using the product, please
familiarise yourself with all of the safety information
and instructions for use. Only use the unit as described
and for the specified applications. If you pass the
product on to anyone else, please ensure that you
also pass on all the documentation with it.
Q Proper use
The device is intended for sawing, cutting and sand-
ing. The preferred materials on which the device
can be used are: wood, plastic, drywalling, non-fer-
rous metals, fixings (e.g. nails, screws) and wall
tiles. It is particularly suitable for working close to
edges and precise work. Any other use or modifi-
cation to the device shall be considered as improper
use and could give rise to considerable dangers. We
will not accept liability for loss or damage arising
from improper use. Not suitable for commercial use.
Q
Features and equipment
1 ON / OFF switch
2 Oscillation speed setting wheel
3 Ventilation slots
4 Clamping plate
5 Plunge saw blade (20 mm) Z20 A2
6 Plunge saw blade (32 mm) Z32 A2
7 Backing plate
8 Segment saw blade Z85 A2
9 Scraping knife Z52 A2
10 Clamping screw
11 Allen key
12 Sanding sheet
13 Vacuum dust extraction assembly (3-piece)
13 a Housing attachment
13 b Vacuum dust extraction duct
13 c Ring connector
Q Included items
1 Multi-Purpose Tool PMFW 310 A1
1 Plunge saw blade (20 mm) Z20 A2
1 Plunge saw blade (32 mm) Z32 A2
1 Clamping screw and clamping plate (prefitted)
1 Backing plate
1 Segment saw blade Z85 A2
1 Scraping knife Z52 A2
18 Sanding sheets
1 Dust extraction system
1 Allen key
1 Carrying case
1 Operating instructions
Q Technical data
Rated power consumption: 310 W
Rated voltage:
230 V∼ 50 Hz
No-load rotational speed: n
0
15000–21000 min -1
Protection class: II /
Noise and vibration data:
Measured values for noise are determined in ac-
cordance with EN 60745. The A-weighted noise
level of the electrical power tool are typically:
Sound pressure level:
84.97 dB(A)
Sound power level: 95.97 dB(A)
Uncertainty K: 3 dB
Wear ear protection!
The total vibration (vector sum of three directions) is
calculated in accordance with EN 60745:
Sanding:
Vibration emission value a
h
= 8.38 m / s 2 ,
Uncertainty K = 1.5 m / s 2
The vibration level specified in
these instructions was measured in accordance with
an EN 60745 standardised measurement process
and can be used to compare equipment. The vibra-