Parkside PDS 290 A1 - Manual (Page 26)

26 GB
Removal:
Pull the hose of the dust extraction device off
the adapter for external vacuum extraction
7 .
Turn anticlockwise to unlock the dust extraction
port
4 .
Pull off the adapter for external vacuum extrac-
tion
7 (with the reducer piece 8 if used).
Q Attaching / detaching
sanding sheets
Always pull the mains plug is out
of the socket before doing any work on the device.
Attaching:
Sanding sheets are attached to the backing plate
6 by means of the hook and pile fastening.
Detaching:
Simply pull the sanding sheet off the backing
plate
6 (see Fig. B).
Materials:
Wood (sanding sheets included), paint*, stone*
*depending on the sanding sheet
Q Turn the backing plate
in 60° steps
Always pull the mains plug out
of the socket before doing any work on the device.
Turn the backing plate 6 of the delta sander
in 60° steps until it engages in the desired
position (see Fig. C).
Sanding output and surfaces:
The shape of the delta sander allows you to sand
workpieces even in their difficult to access places,
corners and edges (see Fig. D).
Sanding performance and surface quality depend
on the grade of sanding sheet and the oscillation
speed setting.
Always use sanding sheets with grades that
are suitable for the particular surface you are
sanding. The speed selected should also be
appropriate to the task undertaken.
Q Advice on use
Switch the device on before placing it against
the workpiece.
Apply light sanding pressure only.
Advance the device at an even rate.
Change sanding sheets at the appropriate time.
Do not work on different types of material using
the same sanding sheet (e.g. wood and then
metal). To achieve the best sanding results you
should use unworn, undamaged sanding sheets.
Clean the sanding sheet from time to time with
a vacuum cleaner.
Q
Maintenance and cleaning
Always pull the mains plug out
of the socket before doing any work on the device.
The delta sander is maintenance-free.
Clean the device frequently. This should be done
immediately after you have finished using it.
For cleaning the housing use a dry cloth only.
Remove any adhering sanding dust with a nar-
row paint brush.
Never any kind of sharp object or petrol, solvents
or cleaning agents that might attack plastic. Do
not allow any liquids to enter the inside of the
device.
Always keep the ventilation slots 5 clear.
Q
Service centre
Have your device re-
paired only by qualified specialist
personnel using original manufacturer
parts only. This will ensure that your device
remains safe to use.
If the plug or mains
lead needs to be replaced, always have
the replacement carried out by the
manufacturer or its service centre. This
will ensure that your device remains safe to use.
Preparing for use / Maintenance and cleaning / Service centre Service centre / Warranty / Disposal