Parkside PWSA 18 A1 - Manual (Page 36)

36
GB MT
field which, under certain circum-
stances, may impair the functionality of
active or passive medical implants. To
reduce the risk of serious or lethal inju-
ries, we recommend that persons with
medical implants consult their doctor
and the manufacturer of their medical
implant before operating the machine.
Safety instructions for all ap-
plications
Common safety instructions for
grinding, sanding, working with
wire brushes and cutting grinders:
• This electric tool is to be used as
a grinder, sander, wire brush
and cutting grinder. Follow all
safety instructions, directives, il-
lustrations and facts which you
receive with the device. If you do
not follow these instructions, an electri-
cal shock, fire and/or serious injury
may occur.
• This electric tool is not suitable
for cup brushes. Using the electric
tool in ways for which it is not intended
may cause hazards and injuries.
• This electric tool is not suitable
for cup wheels, mounted points
or grinding cones. Using the electric
tool in ways for which it is not intended
may cause hazards and injuries.
• This electric tool is not suitable
for polishing. Using the electric tool
in ways for which it is not intended may
cause hazards and injuries.
• Do not use any accessories that
are not specifically intended and
recommended for this electric
tool by the manufacturer. Simply
because an accessory can be attached
to your electric tool does not guarantee
safe operation.
• The allowable rotation speed of
the attachment tools must be at
least as high as the highest rota-
tion speed indicated on the elec-
tric tool. Accessories that run faster
than the allowable speed can break
and fly apart.
• The outside diameter and thick-
ness of the attachment tool must
correspond to the dimensions
indicated for your electric tool.
Attachment tools which are wrongly
dimensioned cannot be sufficiently
shielded or controlled.
• Attachment tools with threaded
attachment must fit the thread-
ing of the grinding spindle ex-
actly. For attachment tools which
are mounted through a flange,
the diameter of the hole in the
attachment tool must fit the
mounting diameter of the flange.
Attachment tools which cannot be pre-
cisely attached to the electric tool turn
unevenly, vibrate very strongly and can
ultimately lead to a loss of control.
• Never use damaged attachment
tools. Check attachment tools
such as grinding discs for chip-
ping or cracks, grinding plates
for cracks, wear or strong abra-
sion and wire brushes for loose
or broken wires before using
them. If the electric tool or the
attachment tool falls off, check
whether it is damaged or, use
an undamaged attachment tool.
If you have checked the at-
tachment tool and attached it,
keep yourself and any nearby
persons beyond the level of the
rotating attachment tool and al-
low the device to run for 1 min.