Parkside PEXS 270 A1 - Manual (Page 32)

32 GB
clothing and gloves away from mov-
ing parts. Loose clothes, jewellery or long
hair can be caught in moving parts.
g) If devices are provided for the connec-
tion of dust extraction and collection
facilities, ensure these are connected
and properly used. Use of dust collection
can reduce dust-related hazards.
4. Power tool use and care
a) Do not force the power tool. Use the
correct power tool for your application.
The correct power tool will do the job better
and safer at the rate for which it was designed.
b) Do not use the power tool if the switch
does not turn it on and off. Any power
tool that cannot be controlled with the switch is
dangerous and must be repaired.
c) Disconnect the plug from the power
source and / or the battery pack from
the power tool before making any ad-
justments, changing accessories, or
storing power tools. Such preventive safety
measures reduce the risk of starting the power
tool accidentally.
d) Store idle power tools out of the reach
of children and do not allow persons
unfamiliar with the power tool or these
instructions to operate the power tool.
Power tools are dangerous in the hands of un-
trained users.
e) Maintain power tools. Check for mis-
alignment or binding of moving parts,
breakage of parts and any other con-
dition that may affect the power tool’s
operation. If damaged, have the power
tool repaired before use. Many accidents
are caused by poorly maintained power tools.
f) Keep cutting tools sharp and clean.
Properly maintained cutting tools with sharp
cutting edges are less likely to bind and are
easier to control.
g) Use the power tool, accessories and
tool bits etc. in accordance with these
instructions, taking into account the
working conditions and the work to
be performed. Use of the power tool for
operations different from those intended could
result in a hazardous situation.
5. Service
a) Have your power tool serviced by a
qualified repair person using only iden-
tical replacement parts. This will ensure
that the safety of the power tool is maintained.
Safety advice relating specifi-
cally to random orbital sanders
POISONOUS DUSTS!
The working of materials that can produce
harmful / toxic dusts presents a health risk for
the operator and for people located in the
close vicinity.
Avoid sanding lead-based paints or
other materials that are hazardous to
health.
Material containing asbestos may not
be worked. Asbestos is considered to be a
carcinogen.
Wear safety glasses and a dust pro-
tection mask!
Secure the workpiece firmly. Use
clamps or a vice to firmly hold the workpiece.
This results in a safer grip than with your hand.
Under no circumstances should you
place your hands next to or in front of
the appliance or on the area to be
worked, you could be seriously injured if you
slip or stumble.
Always run the power cable away
from the appliance to the rear.
Ensure that nobody is endangered by
flying sparks. Remove combustible materials
from the immediate vicinity. Flying sparks are
produced when metals are ground.
CAUTION! DANGER OF FIRE! Ensure that
the material being ground and the
grinder itself do not overheat. Always
General power tool safety warnings