Parkside PEXS 270 A1 - Manual (Page 26)

26 GB
adapter for external exhaust suction 7 , using
the reducing piece if necessary 8 .
Removal:
Pull the hose of the suction device off the
adapter for external exhaust suc-tion
7 .
Turn the adapter for external exhaust suction 7
in an anticlockwise direction and pull it off with
the reducing piece
8 if necessary.
Q
Commissioning
Q
Switching on and off
Note! Always switch the rotary sander on before
applying it to the material to be worked, then make
contact with it.
When operating the device you can select between
intermittent or continuous operation mode:
To switch on intermittent operation mode:
Press the oN / oFF switch 1 .
To switch off intermittent operation mode:
Release the oN / oFF switch 1 .
Switching on continuous operation:
Press the oN / oFF switch 1 , keep it pressed
down and press the locking button 2 .
Switching off after sustained operation:
Press the oN / oFF switch 1 and then release it.
Q
Working instructions
Wait until the electric tool has stopped moving
before you put it down.
Q
Grinding Surfaces
Turn the electric tool on, place the entire grinding
surface on the substrate that is to be worked
on and move it with moderate pressure across
the workpiece (see Illustration B, C, D).
Note: The rate of metal removal and the
grinding pattern are essentially determined by
the grinding disc that has been selected and
the grinding pressure. only grind-ing discs that
are in perfect condition will provide good
grinding performance.
Please ensure that the grinding pressure is
even. An excessive increase in the grinding
pressure leads not only to a higher rate of met-
al removal, but also greater wear and tear on
the grinding disc.
You should not use a grinding disc that has
been used for working metal for other materials.
Q
Maintenance and Cleaning
The rotary sander is maintenance free.
Clean the appliance regularly, preferably direct-
ly on completion of the task.
Use a dry cloth to clean the device. Under no
circumstances should you use petrol, solvent or
cleaners which attack plastic.
Keep the ventilation openings clear at all times.
Remove dust clinging to the sander with a brush.
Q
Service centre
Have your device
repaired only by qualified specialist
personnel using original manufacturer
parts only. This will ensure that your device
remains safe to use.
If the plug or mains
lead needs to be replaced, always have
the replacement carried out by the
manufacturer or its service centre. This
will ensure that your device remains safe to use.
Note: Spare parts not listed (e.g. carbon brushes,
switches) can be ordered through our call centre.
… / … / Working instructions / Maintenance and Cleaning / Service centre