Parkside PSS 250 A1 - Manual (Page 39)

39 GB/MT
General power tool safety warnings / Operation General power tool safety warnings
on materials that give rise to dusts that are haz-
ardous to health, the sander must be connected
to a suitable external dust extraction device.
Wear protective glasses and a dust
mask!
Ensure sufficient ventilation when
working on plastics, paints, lacquers,
etc.
Do not soak materials or surfaces to be
worked with liquids containing solvents.
Avoid sanding of lead-based paints or
other materials that are hazardous to
health.
Material containing asbestos may not
be worked on. Asbestos is considered a
carcinogen.
The appliance is designed for dry sur-
face sanding of wood, plastic, metal
and smoothing compounds as well as
painted surfaces.
Never work on moistened materials
or wet surfaces. Water entering an electri-
cal device increases the risk of electric shock.
Always hold the appliance firmly with
two hands while working (see also
Fig. D, E).
Never support your hands next to or
in front of the device or on the surface
being worked as there is a risk of in-
jury in the event of slipping.
Always switch off the appliance and
allow the sanding sheet
9 to come to
a stop before setting down the oscil-
lating sander.
Always pull the power plug out of the
socket for all work pauses, before any
work on the appliance (e.g. changing
the sanding paper) and when not in use.
The appliance must always be kept
clean, dry and free of oil or lubricat-
ing greases.
original ancillaries / and
accessories
only use accessories and tools that are
specified in the operating instructions.
The use of tools and accessories other than
those recommended in the operating instructions
could lead to an increased risk of personal in-
jury for you.
operation
Switching on and off
Switching on intermittent function:
Press the ON / OFF switch 1 .
Switching off intermittent function:
Release the ON / OFF switch 1 .
Switching on continuous operation:
Press the ON / OFF switch 1 , hold it pressed
and press the locking button 2 .
Switching off continuous operation:
Press the ON / OFF switch 1 then release it
again.
Setting the oscillation speed
You can set the desired oscillation speed as needed
with the oscillation speed selector
10 .
The required oscillation speed depends on the ma-
terial being worked and can be determined through
practical tests.
Attaching a sanding sheet
Before performing work on the
appliance, always disconnect the power.
NoTE: Before attaching a new sanding sheet
9 ,
remove dust and dirt from the sanding plate 8 .
Sanding sheets with hook and loop
fastening:
Fix one side of the sanding sheet 9 flush with
one side of the backing plate 8 .
Then attach the sanding sheet 9 to the back-
ing plate 8 and press it firmly into place.