Parkside PABS 14.4 A1 - Manual (Page 12)

12 GB/IE
Disposal / Conformity Declaration / Manufacturer Operation / Maintenance and Cleaning / Warranty
Mark the intended position of the hole with a
centre punch or a nail and select a low drill
speed for drilling.
Take the rotating drill bit out of the hole frequently
so that swarf or drill dust can be re-moved and
the hole and tool is ventilated.
Drilling in metal:
Use a metal drill bit (HSS). For the best results,
you should cool the bit with oil. Metal drill bits
can also be used to drill into plastic.
Drilling in stone:
Use a circular shafted masonry drill bit with a
hardened metal tip.
Drilling in wood:
Normally you should use a wood drill with a
centring point. For deep holes, use an auger type
bit. For large diameter holes, use a forstner bit.
You can screw small screws into soft wood
without the need for pre-drilling.
Maintenance and Cleaning
RISK OF INJURY! Switch the
device off, unplug from the mains socket and remove
the battery before performing any work on the device.
The cordless drill is maintenance-free.
Always keep the device clean, dry and free of
oil or grease.
Use a dry cloth to clean the housing.
If the connection cable needs to
be replaced, this repair must be performed by
the manufacturer or a representative to prevent
safety hazards.
Warranty
The warranty for this appliance is for 3
years from the date of purchase. The ap-
pliance has been manufactured with care
and meticulously examined before deliv-
ery. Please retain your receipt as proof
of purchase. In the event of a warranty
claim, please make contact by telephone
with our Service Department. Only in this
way can a post-free despatch for your
goods be assured.
The warranty covers only claims for material and
maufacturing defects, but not for transport damage,
for wearing parts or for damage to fragile compo-
nents, e.g. buttons or batteries. This product is for pri-
vate use only and is not intended for commercial use.
The warranty is void in the case of abusive and im-
proper handling, use of force and internal tampering
not carried out by our authorized service branch. Your
statutory rights are not restricted in any way by this
warranty.
The warranty period will not be extended by repairs
made unter warranty. This applies also to replaced
and repaired parts. Any damage and defects extant
on purchase must be reported immediately after
unpacking the appliance, at the latest, two days after
the purchase date. Repairs made after the expiration
of the warranty period are subject to payment.
GB
Service Great Britain
Tel.:
0871 5000 720
(0,10 GBP / Min.)
e-mail: [email protected]
IAN 93498
IE
Service Ireland
Tel:
1890 930 034
(0,08 EUR / Min. (peak)
0,06 EUR / Min. (off peak))
e-mail: [email protected]
IAN 93498