beautypg.com

Start-up / operation, Original accessories / tools, Start-up – Parkside PABS 14.4 A1 User Manual

Page 30: Charging the battery pack, Checking battery status, Changing tools, Torque pre-selection

background image

30 GB

General safety advice for electrical power tools / Start-up

position (lock). Therefore preventing the
power tool from starting unintentionally.

DANGER! Check that you will not hit
electric, gas or water lines whilst using
the power tool.
Check, if need be with a
service line detector, before you start to cut or
bore into a surface.

Original accessories / tools

Use only the accessories and attachments
detailed in the operating instructions,
or those which are compatible with
the device.

Start-up

Charging the battery pack

CAUTION! Always ensure the plug is removed

from the mains socket before inserting a battery pack
into, or removing one from, the charging station.

Never charge the battery pack if the ambient
temperature is less than 10 °C or greater than
40 °C.

1. Insert the battery pack

4

in the quick charger

11

(see Fig. C).

2. Insert the mains plug into the mains socket. The

status LED

12

will light up red.

3. The green charging status LED

13

indicates the

charging process has been completed and the
battery pack

4

is ready for use.

4. Slide the battery pack

4

into the unit.

Never charge the battery pack for a second time
immediately after a fast charging process has
been completed. This can give rise to the battery
pack becoming overcharged and to a reduced
service life of the battery and charging station.

Switch the charger off for at least 15 minutes
between two successive charging procedures.
Remove the power plug from the wall socket.

Insertion / removal of a battery

pack into the appliance

Inserting the rechargeable battery pack:

Move the rotary direction switch

2

into the

middle position (lock). Push the rechargeable
battery pack

4

into the handle until it engages.

Removing the rechargeable battery pack:

Press the release button

5

and remove the

rechargeable battery pack

Checking battery status

Press the battery LED

7

to check the battery

condition (also see main image). The battery
display LED

6

will indicate the status or the

remaining charge as follows:
GREEN / RED / ORANGE = maximum charge /
capacity
RED / ORANGE = medium charge / capacity
RED = weak charge – recharge battery

Changing tools

Your cordless drill has a fully automatic spindle
lock

.

When the motor stops the power train will lock so
that you can open the drill chuck

9

by turning it.

After you have inserted the required bit and fixed it
in place by turning the chuck

, you can immedi-

ately continue working. The spindle lock releases
itself automatically when the motor is started (by
operation of the ON / OFF switch

3

).

Torque pre-selection

You can adjust the torque by using torque pre-se-
lection

10

.

Select a low setting for small screws, soft work
material.

Select a high setting for large screws, hard
work materials and for the extraction of screws.

Start-up / Operation