Parkside AIR RATCHET SET PDRS - Manual (Page 12)

12 GB
Information about … / Environmental instructions and disposal information … / Start-up / After initial use / Maintenance / Cleaning … / Information about …
Do not exceed the maximum air pressure stated
on the tool.
For torque-control and continuous-rotation tools,
the air pressure has a safety critical effect on
performance. Therefore, requirements for length
and diameter of the hose shall be specified.
Never carry an air tool by the hose.
Start-up (see Fig. B / C)
Screw the included plug nipples 4 into the air
connection after first wrapping the thread with
2–3 layers of sealing tape (not included).
Attach the required plug-in attachment to the
square intake.
Set the correct direction of rotation on the pivot
bolt
11 :
R = counterclockwise / remove screw,
F = clockwise / tighten screw.
Attach the plug-in attachment to the screw head.
Activate the trigger 2 .
Note: the connection to the compressed air source
is established through a flexible air hose with quick
connector.
The ratcheting screwdriver will perform best when
used with an LW 10 mm air hose.
After initial use
Once the task has been finished the equipment must
be disconnect from the compressed air supply
3 .
Maintenance
Following the maintenance information specified here
will ensure a long service life for the product and
trouble-free operation. Your ratchet screwdriver work-
ing properly for a long time requires daily lubrication.
You may choose from the following options:
With an oil-fog lubricator
A complete maintenance unit includes an oil-fog
lubricator and is attached to the compressor.
Manually
Add 3–5 drops of speciality tool oil to the compressed
air connection before every use. If the compressed
air tool is not being used for several days, add 5–10
drops of oil to the compressed air connection be-
fore switching it on.
Always store your compressed air tools in dry
rooms.
Cleaning and Care
Never clean with liquids such as petrol, solvents
or water.
Do not allow liquids to enter the tool.
Only clean the tool with a dry cloth.
Information about warranty
and service processing
Creative Marketing Consulting GmbH
warranty
Dear customer,
the warranty for this device is 3 years from the date
of purchase. In the event of product defects, you
have legal rights against the retailer of this product.
Your statutory rights are not limited in any way by
our warranty detailed below.
Warranty terms
The warranty period begins on the date of purchase.
Please retain the original receipt safely. This docu-
ment is required as your proof of purchase.
Should this device show any fault in materials or ma-
nufacture within three years from date of purchase,
it will be repaired or replaced – at our choice – by
us free of charge. This warranty is conditional on the
defective device and the proof of purchase (receipt)
being presented within the three year warranty pe-
riod, and that there is a brief written description of
the nature of the defect and of the date it arose.
If the defect is covered by our warranty, we will re-
turn the repaired device or replacement thereof. A
43095_par_Druckluft-Ratschenschrauber PDRS_content_SI_CZ.indd 12 28.05.14 11:15