Parkside PAS 500 D3 - Manual (Page 12)

12
GB
Trouble shooting
Problem Possible cause Fault correction
Device does not start
Mains voltage is not present
Check plug socket, power cord,
line, plug and fuse, where ap-
propriate, repair through electri-
cal specialist
The equipment is not
switched on
Switch on the equipment (see
“switching on/off“)
Safety stop due to missing
or incorrectly inserted pleat-
ed filter ( 13) or metal
filter cage ( 14)
Insert the pleated filter correctly
(see “cleaning/maintenance“)
Defective on/off switch
( 6)
Repair through customer service
Defective motor
The single-use thermal fuse
has disconnected the power
circuit
Low or lack of suction
Suction hose ( 11) or suc-
tion tube ( 12) blocked
Remove obstructions and block-
ages
The metal container ( 10)
is not closed
Close the metal container
The metal container ( 10)
is full
Empty the metal container (see
“cleaning/maintenance“)
The pleated filter ( 13) is
clogged
Clean or replace the pleated
filter (see “cleaning/mainte-
nance“)
The air filter ( 18) is
clogged
Clean the air filter (see “clean-
ing/maintenance“)
Pre-filter ( 15) is clogged Clean or replace pre-filter (see
"Cleaning/Maintenance")
Pre-filter ( 15) reduces
the suction power
To vacuum coarse dirt, remove
the pre-filter