Parkside PSBS 240 B2 - Manual (Page 14)

14
GB
Before each use, check the equipment
for obvious defects such as loose, worn
or damaged components and check that
screws or other parts are sitting correctly.
In particular, check the grinding disk (
19). Replace damaged parts.
Cleaning
Do not use cleaning agents or sol-
vents. Chemical substances may
attack plastic parts of the equipment.
Never clean the equipment under
running water.
• Clean the equipment thoroughly after
each use.
• Clean the ventilation openings and the
surface of the equipment with a brush
or cloth.
Storage
• Store the appliance in a dry place well
out of reach of children.
• Grinding disks must be stored dry and
upright and are not to be stacked.
Waste disposal and en-
vironmental protection
Be environmentally friendly. Return the
tool, accessories and packaging to a recy-
cling centre when you have finished with
them.
Machines are not to be place with
domestic waste.
Hand over the device at an utilization loca-
tion. The plastic and metal parts employed
can be separated out into pure materials
and recycling can be implemented. Ask
your Service Center about this. Defective
units returned to us will be disposed of for
free.
Replacement parts/accessories
Spare parts and accessories can be obtained at www.grizzly-service.eu
If you do not have internet access, please contact the Service Centre via telephone
(see “Service-Center” page 17). Please have the order number mentioned below ready.
Position Position Description Order
Instruction Exploded number
manual drawing
1,2 Set 3 Spark protection with adjusting screw 91103042
10 35 Grinding belt 91103044
Grinding belt, pack of 5 91103046
14 Set 2 On/off-switch 91103041
19 62 Grinding disk 91103043
19a,19b Set 1 Grinding disk nut and clamping flange 91103040