Parkside PHS 160 B3 - Manual (Page 9)

6 PHS 160 B3
GB
Reducer piece
Connection:
♦ Push the reducer piece into the adapter
port .
♦ Push the hose of a suitable dust extraction
device approved for that purpose (e.g. a
workshop vacuum cleaner) on to the reducer
piece
.
Removal:
♦ Pull the dust extraction device hose off the
reducer piece
.
♦ Pull off the reducer piece .
Attaching / detaching sanding sheets
WARNING!
► Always pull the mains plug is out of the socket
before doing any work on the device.
Attaching:
♦ Sanding sheets are attached to the backing
plate by means of the hook and pile fasten-
ing.
Detaching:
♦ Simply pull the sanding sheet off the backing
plate (see Fig. A).
Rotating the backing plate
WARNING!
► Always pull the mains plug is out of the socket
before doing any work on the device.
♦ Rotate the backing plate into the desired
position (see Fig. B).
Sanding and surfaces:
The sanding output and the quality of the surface
fi nish are determined by the grade of grit on the
sanding sheet.
♦ Always use sanding sheets with grades that
are suitable for the particular surface you are
sanding.
Advice on use
■ Switch the device on before placing it against
the workpiece.
■ Apply light sanding pressure only.
■ Advance the device at an even rate.
■ Change sanding sheets at the appropriate time.
■ Do not work on diff erent types of material using
the same sanding sheet (e.g. wood and then
metal). To achieve the best sanding results you
should use unworn, undamaged sanding sheets.
■ Clean the sanding sheet from time to time with
a vacuum cleaner.
■ Sand diffi cult to reach places with the front or
side corners of the backing plate .
■ Work in parallel and overlapping widths.
■ After sanding the workpiece, lift the device from
the workpiece before switching it off .
Maintenance and cleaning
WARNING!
► Always pull the mains plug is out of the socket
before doing any work on the device.
The delta sander is maintenance-free.
■ Clean the device frequently. This should be done
immediately after you have fi nished using it.
■ For cleaning the housing use a dry cloth only.
■ Remove any adhering sanding dust with a nar-
row paint brush.
■ Never any kind of sharp object or petrol,
solvents or cleaning agents that might attack
plastic. Do not allow any liquids to enter the
inside of the device.
■ Always keep the ventilation slots clear.
IB_100087_PHS160B3_LB4.indb 6 03.06.14 17:00