Parkside PSE 2800 B2 - Manual (Page 46)

46 GB/MT
Cleaning, maintenance, storage, transport and ordering of spare parts Operation / Cleaning, maintenance, storage, transport and ordering of spare parts
Starting the engine
IMPortAnt!
When starting with the reserve starter 12 , the motor
may recoil suddenly as it starts up, resulting in hand
injuries.
Wear protective gloves when starting
the equipment.
Open the petrol cock 13 by turning it down.
Set the ON / OFF switch 10 to the “ON”
position.
Move the choke lever 11 to position I Ø I.
Start the engine with the reversing starter 12 ,
by pulling forcefully on the handle. If the engine
does not start, pull the handle again.
Push the choke lever 11 back after the engine
has started.
Connecting consumers
to the generator
Connect the equipment you want to use to the
230 V~sockets
3 .
IMPortAnt! These sockets may be loaded
continuously (S1) with 2600 W and temporarily
(S2) for a maximum of 2 minutes with 2800 W.
J The generator is suitable for 230 V~ AC appli-
ances only.
Do not connect the generator to the household
mains system as this may result in damage to
the generator itself or to other electrical appli-
ances in your home.
note: Some electrical appliances (power jigsaws,
drills, etc.) may have a higher level of power con-
sumption when used in difficult conditions
Switching off the engine
Before you switch off the generator, allow it to
run briefly with no consumers so that it can
“cool down”.
Set the ON / OFF switch 10 to the “OFF”
position.
Close the petrol cock 13 .
overload cut-out 2 x 230 V
socket-outlets
IMPortAnt! the generator is fitted
with an overload cut-out.
This shuts down the sockets
3 . You can restart the
sockets 3 by pressing the overload cut-out 5 .
IMPortAnt! If this happens, reduce
the electric power you are taking from
the generator or remove any defective
connected appliances.
IMPortAnt! Defective overload cut-
outs must be replaced only by overload
cut-outs of identical design and with the
same performance data. If repairs are
necessary, please contact your customer
service center.
Cleaning, maintenance,
storage, transport and
ordering of spare parts
Switch off the motor and pull the spark plug boot
from the spark plug before doing any cleaning and
maintenance work on the equipment.
AttEntIon! Stop the appliance in-
stantly and contact your point of service:
–
In the event of unusual vibrations or noise
– If the engine appears to be overloaded or
misfires
Cleaning
Keep all safety devices, air vents (Fig. A/Item
A1) and the motor housing free of dirt and
dust as far as possible. Wipe the equipment