Parkside PWS 125 A1 - Manual (Page 54)

54 GB/MT
Introduction / General safety advice for electrical power tools Introduction
Angle grinder PWS 125 A1
Grinding, roughing, cutting
Q
Introduction
We congratulate you on the purchase of your new
device. You have chosen a high quality product. The
instructions for use are part of the product. They
contain important information concerning safety,
use and disposal. Before using the product, please
familiarise yourself with all of the safety information
and instructions for use. Only use the unit as described
and for the specified applications. If you pass the
product on to anyone else, please ensure that you
also pass on all the documentation with it.
Q
Proper use
This tool is suitable for cutting, roughening and
brushing metal materials without the use of water.
Any other use or modification to the device shall be
considered as improper use and could give rise to
considerable dangers. We will not accept liability
for loss or damage arising from improper use. The
device is not intended for commercial use.
Note: Slots cut in load-bearing walls must comply
with standard DIN 1053 Part 1 or the regulations
applicable in your country.
These instructions and advice must be observed.
Before you start a task, seek the advice of a com-
petent structural engineer, architect, or the relevant
site management staff.
Q
Features and equipment
1 Safety lock-out
2 ON / OFF switch
3 Carbon brushes cover
4 Auxiliary handle
5 Adjustable disc guard
6 Clamping nut
7 Mounting spindle
8 Mounting flange
9 Spindle lock button
10 Speed pre-selector wheel
11 Spanner (Fig. B)
Q
Included items
1 Angle grinder PWS 125 A1
1 Metal-cutting disc
1 Auxiliary handle
1 Disc guard cover
1 Spanner
1 Operating instructions
Q
Technical information
Rated input: 1200 W
Rated voltage: 230–240 V∼, 50 Hz
Rated no-load speed: n 12000 rpm
Variable rotation speed: 3000 to 12000 rpm
Spindle thread:
M14
Protection class: II /
Noise and vibration data:
Measured values for noise are determined in accor-
dance with EN 60745. The A-weighted noise level
of the electrical power tool are typically:
Sound pressure level:
91 dB(A)
Sound power level: 102 dB(A)
Uncertainty K: 3 dB
Wear hearing protection!
Vibration total values determined
according to EN 60745:
Surface grinding:
Vibration emission value a
h, AG
= 13.431 m/s 2 ,
Uncertainty K = 1.5 m/s 2 .
The vibration level specified in
these instructions was measured in accordance with
an EN 60745 standardised measurement process
and can be used to compare equipment. The vibra-
tion emission value specified can also serve as a
preliminary assessment of the exposure.
The vibration level will change according to the ap-
plication of the electrical tool an in some cases may
exceed the value specified in these instructions.