Parkside PFBS 9.6 A1 - Manual (Page 14)

14 GB
Operation / Maintenance and cleaning / Service / Warranty Operation
Q Inserting or replacing
a tool / collet
Press the spindle lock 8 and keep it pressed.
Rotate the clamping nut 6 until the lock
engages.
Loosen the clamping nut 6 with the combina-
tion key 23 .
If a tool is already inserted, remove it.
First insert the tool you wish to use through the
clamping nut
6 before you insert it into the
collet 18 suitable for the tool shaft.
Press the spindle lock 8 and keep it pressed.
Insert the collet 18 into the threaded insert and
tighten the clamping nut 6 on the thread using
the combination key 23 .
NOTE: Use the screwdriver end of the combi-
nation key
23 to release or tighten the screw of
the mandrels 13 .
Q Switching on and off / Setting
the speed range
Switching on / Setting the speed range:
Set the ON / OFF switch 5 to position “I”.
Set the rotational speed control 1 to a position
between „1“ and „MAX.“.
Switching off:
Set the ON / OFF switch 5 to position “0”.
Q Advice on working with
materials / Tools / Speed ranges
Use the highest speed when working on steel
or iron with the milling bits.
Use a short trial on a test piece to determine the
optimum rotational speed range for working on
zinc, zinc alloy, aluminium, copper and lead.
Use the low speed range for working on plastics
and low-melting point materials.
Use high speeds on wood.
Use the medium speed range for cleaning,
polishing and buffing.
The following information shall be considered as
recommendatory only. Learn by practical experience
which tools and settings are the best for the materi-
als you work with.
Setting the appropriate speed
Symbols
Rotational
speed
control
1
Material
1–3 Plastics and low melting
point materials 6–7 Hardwood
4–5 Stone, Ceramics Max Steel
5 Softwood, metal
Examples of appropriate tool selection Function
Function Accessory Application
Drilling HSS drill 12 Drilling wood (see Fig. C)
Milling Milling bits 21 Various tasks, e.g. hollowing out, gouging,
shaping, grooving or slotting
Engraving Engraving bits 20 Markings (see Fig. D)