Parkside PFBS 9.6 A1 - Manual (Page 13)

13 GB/IE
General safety advice for electrical power tools / Operation General safety advice for electrical power tools
in any danger and that there are no inflammable
materials near the working area.
DUST HAZARD! Any
harmful / noxious dusts generated from machin-
ing represent a risk to the health of the person
operating the device and to anyone near the
work area.
Wear a dust mask!
NOXIOUS FUMES!
Ensure that there is adequate ventilation when
machining surfaces containing plastic or cov-
ered with paint, varnish etc.
Its use as a saw or the use of saw blades with
this device is prohibited.
Do not soak the materials or the surface you
are about to work on with liquids containing
solvents.
Avoid abrading paints containing lead or other
substances hazardous to health.
Do not machine materials containing asbestos.
Asbestos is a known carcinogen.
Avoid contact with moving sanding or grinding
tools.
Do not machine moist materials or damp sur-
faces.
NOTE! Do not allow the tool to come to a
standstill by overloading it!
RISK OF INJURY!
Switch the device off and allow it to come to a
standstill before you put it down.
Always keep the device
clean, dry and free of oil or grease.
Children or persons who lack the knowledge or
experience to use the device or whose physical,
sensory or intellectual capacities are limited
must never be allowed to use the device without
supervision or instruction by a person responsi-
ble for their safety. Children must never be
allowed to play with the device.
Q
Operation
Never use the device for a purpose for which it was
not intended or with non-original parts / accessories.
The use of tools or accessories other than those rec-
ommended in the operating instructions could lead
to you suffering an injury.
Q Charging the battery pack
NOTE! A battery pack that has been unused for a
while or never been charged must be charged before
reuse or first use. The battery pack requires about
3–5 cycles before it can reach its full charge. The
charging process takes about 180 minutes.
CAUTION! RISK OF INJURY! Always pull
out the mains plug (mains adapter
10 ) before
you insert the battery pack into or take it out of
the charger.
Connect the adapter 10 to a mains socket.
Insert the battery pack 3 a into the charging
cradle 9 . This can only be inserted with the
correct polarity.
The LED 11 lights up green whenever the bat-
tery pack 3 a is in the charging cradle 9 and
the adapter 10 is connected to a mains socket.
CAUTION! Do not charge a battery pack for
a second time in close succession. There is a
danger of overcharging the battery pack.
Q Inserting / removing the
battery pack into / out of the
drill / grinder
Inserting the battery pack:
Set the ON / OFF switch 5 to position “0”.
Insert the battery pack 3 a into the drill / grinder
until it engages.
Removing the battery pack:
Pressing the battery pack buttons 3 at the
sides at the same time allows you to remove
the battery pack
3 a .
Q
Reading off the battery status
The status or residual power is indicated as follows
in the battery-operated LED
2 whenever the appli-
ance is switched on:
RED / ORANGE / GREEN = maximum charge / power
RED / ORANGE = medium-level charge / power
RED = weak charge – recharge battery