Parkside PLBS 30 A1 - Manual (Page 58)

58 GB/MT
DANGER OF BURNS! Never touch the hot soldering tip or the
molten solder. You could suffer burn injuries. Always let the device
cool before you replace components on the device, clean it or check
its condition.
After use let the soldering pencil cool down in air only. Under no
circumstances quench the tip in water!
CAUTION! DANGER OF FIRE! Place the soldering pencil down
only in the special multifunctional holder or on a fire-resistant pad.
Place the soldering pencil in the multifunctional holder during
pauses in your work.
Keep the device away from combustible material.
Never leave the device switched on and unattended.
CAUTION! DANGER OF INJURY! Keep your hands away
from the hot workpiece. The heat from soldering can be conducted
through the workpiece. For this reason you should use the third
hand to hold small workpieces.
Avoid placing the hot soldering tip in contact with the plastic parts
of the multifunctional holder. Failure to observe this advice may
result in damage to the device.
If a dangerous situation arises, pull the mains plug immediately
out of the mains socket.
CAUTION! DANGER OF POISONING! Do not breathe air
contaminated with soldering fumes.
When working with the device for long periods do not allow the
fumes from soldering to build up. They may be hazardous to
health. Always provide adequate ventilation of your working area.
In addition, it is recommended that you wear protective gloves, a
face mask and a protective apron.
Do not eat, drink or smoke in rooms where soldering is carried
out. Otherwise your hands may transfer any adhering traces of
lead via food or cigarettes into your body.
Always wash your hands immediately after soldering .
Safety advice Safety advice