Parkside PFBS 9.6 A1 - Manual (Page 57)

57 GB/MT
Q Switching on and off / Setting
the speed range
Switching on / Setting the speed range:
Set the ON / OFF switch 5 to position “I”.
Set the rotational speed control 1 to a position
between „1“ and „MAX.“.
Switching off:
Set the ON / OFF switch 5 to position “0”.
Q Advice on working with
materials / Tools / Speed ranges
Use the highest speed when working on steel
or iron with the milling bits.
Use a short trial on a test piece to determine the
optimum rotational speed range for working on
zinc, zinc alloy, aluminium, copper and lead.
Use the low speed range for working on plastics
and low-melting point materials.
Use high speeds on wood.
Use the medium speed range for cleaning,
polishing and buffing.
The following information shall be considered as
recommendatory only. Learn by practical experience
which tools and settings are the best for the materi-
als you work with.
Operation General safety advice for electrical power tools / Operation
Setting the appropriate speed
Symbols
Rotational
speed
control
1
Material
1–3 Plastics and low melting
point materials 6–7 Hardwood
4–5 Stone, Ceramics Max Steel
5 Softwood, metal
Examples of appropriate tool selection Function
Function Accessory Application
Drilling HSS drill 12 Drilling wood (see Fig. C)
Milling Milling bits 21 Various tasks, e.g. hollowing out, gouging,
shaping, grooving or slotting
Engraving Engraving bits 20 Markings (see Fig. D)
Polishing,
derusting
CAUTION!
Use only the lightest
contact pressure of
the tool on the work-
piece.
Metal brush 16 Derusting (see Fig. E)
Polishing wheel 14 Working on various metals and plastics, in
particular noble metals like gold or silver
(see Fig. F)