Parkside PWP 90 A1 - Manual (Page 34)

34 GB/MT
priate for the demands on and condition of your
paintwork. Heavily oxidised paintwork will require
the use of a special cleaner. For this use a combined
product (cleaner + wax).
1. Place the car polisher on the surface to be pol-
ished.
Note: To avoid the splattering of wax or polish,
do not switch the appliance on yet. Dab the
appliance a few times at various points on the
area to be buffed. In this way you can ensure
that excess wax / polish is once more distributed
evenly over the terrycloth bonnet and the area
to be buffed.
2. Take both appliance grips 1 firmly in your
hands and switch the appliance on by pressing
the oN / oFF switch
3 (see also Fig. B).
3. Guide the waxer/polisher evenly over the
paintwork (see Fig. C).
Note: Do not press on the waxer /polisher!
The self-weight of the car polisher alone
applies sufficient pressure for the waxing / pol-
ishing process.
4. Switch the appliance off before you remove it
from the area being buffed. To do this, release
the oN / oFF switch
3 .
Any difficult to reach corners or recesses may
have to be completed later by hand. Take the
terry bonnet
5 off the car polisher and use
the bonnet for the corners and recesses.
Q
Polishing or removing wax with
the synthetic polishing bonnet
Note: The wax / polish must be allowed to dry on
sufficiently to produce the best polishing performance.
otherwise any polish that is still fluid will be smeared
by the polishing bonnet.
Use the synthetic polishing bonnet 6 for final
polishing or removing the wax.
When working, always follow the instructions
for use of the wax / polish.
Q Cleaning and Maintenance
DANGER OF INJURY! Switch
the device off and pull the plug out of the mains socket
before carrying out any work on the device.
CAUTION! Ensure that no fluids can permeate into
the appliance, this could lead to the destruction of
the product.
The appliance is maintenance-free.
Use a slightly moist cloth to clean the housing,
if necessary with a mild detergent.
When cleaning the housing, under no circum-
stances should you use strong detergents,
solvents or abrasives.
Clean the bonnet by washing by hand in
soapy water.
Q Service centre
Have your device
repaired only by qualified specialist
personnel using original manufacturer
parts only. This will ensure that your device
remains safe to use.
If the plug or mains lead
needs to be replaced, always have the
replacement carried out by the manu­
facturer or its service centre. This will
ensure that your device remains safe to use.
Q
Warranty
The warranty for this appliance is for 3 years
from the date of purchase. The appliance
has been manufactured with care and
meticulously examined before delivery.
Please retain your receipt as proof of pur­
chase. In the event of a warranty claim,
please make contact by telephone with our
Service Department. Only in this way can
a post­free despatch for your goods be
assured.
The warranty covers only claims for material and
maufacturing defects, but not for transport damage,
Warranty / Disposal operation / Cleaning and Maintenance / Service centre / Warranty