Parkside PEXS 270 A1 - Manual (Page 40)

40 GB
Q
Original accessories / tools
Use only the accessories detailed in
the operating instructions. The use of
inserted tools or accessories other than those
recommended in the operating instructions
could lead to you suffering an injury.
Q
Before use
Q
Selecting the Grinding Disc
Metal Removal and Surface:
The rate of metal removal and the surface quality
are determined by the grain size of the grinding disc.
Please note that corresponding grinding discs
with different grain sizes should be used for
processing different materials.
Q
Changing sanding sheets
The rotary sander is fitted with a velcro rapid attach-
ment, making possible a quick and easy exchange
of sanding sheets.
Lift the grinding disc 5 at the side and pull it off
from the backing pad 4 in order to remove it.
Note: Before securing a new sanding sheet 5 ,
remove all dust and dirt from the sander plate 4 .
Ensure that the openings in the sanding sheet 5
concur with the boreholes of the sanding plate 4 .
Q
Dust / Swarf Removal by Suction
Please note the “Safety instructions” section.
Removal by Suction with Dust Collector:
Push the dust collector 3 completely onto the
device.
In order to empty the dust collector 3 pull it
off the device.
Note: Empty the dust collector 3 in good time
and regularly in order to ensure the optimum
removal of dust by suction.
External Exhaust Suction (see Illustration A):
Connection:
Push the adapter for external exhaust suction 7
on to the exhaust nozzle 6 and turn it clockwise
to fix it in place. If necessary, use the reducing
piece
8 by pushing it into the adapter for
external exhaust suction 7 .
Push the hose of an approved suction device
(e.g. a workshop vacuum cleaner) on to the
adapter for external exhaust suction
7 , using
the reducing piece if necessary 8 .
Removal:
Pull the hose of the suction device off the
adapter for external exhaust suc-tion
7 .
Turn the adapter for external exhaust suction 7
in an anticlockwise direction and pull it off with
the reducing piece
8 if necessary.
Q
Commissioning
Q
Switching on and off
Note! Always switch the rotary sander on before
applying it to the material to be worked, then make
contact with it.
When operating the device you can select between
intermittent or continuous operation mode:
To switch on intermittent operation mode:
Press the ON / OFF switch 1 .
To switch off intermittent operation mode:
Release the ON / OFF switch 1 .
Switching on continuous operation:
Press the ON / OFF switch 1 , keep it pressed
down and press the locking button 2 .
Switching off after sustained operation:
Press the ON / OFF switch 1 and then release it.
Q
Working instructions
Wait until the electric tool has stopped moving
before you put it down.
General safety advice … / Before use / Commissioning / Working instructions